BS ISO 815-2:2014 硫化橡胶或热塑性橡胶.压缩永久变形的测定.低温条件
Rubber, vulcanized or thermoplastic. Determination of compression set. At low temperatures
BS ISO 815-2:2009 硫化橡胶或热塑性橡胶 压缩永久变形的测定 低温条件
Rubber, vulcanized or thermoplastic. Determination of compression set. At low temperatures
BS ISO 815-2:2008 硫化橡胶或热塑性橡胶.压缩永久变形的测定.低温条件
Rubber, vulcanized or thermoplastic - Determination of compression set - At low temperatures
GB/T 7759.2-2014 硫化橡胶或热塑性橡胶 压缩永久变形的测定 第2部分:在低温条件下
GB/T 7759的本部分规定了在低温条件下测定硫化橡胶或热塑性橡胶压缩永久变形性能的试验方法。本方法用于测量硬度在10 IRHD~95 IRHD范围内的橡胶在规定的温度和压缩率(通常为25%)条件下,经持续压缩后保持其弹性的能力。当橡胶硬度大于80 IRHD时,应选用较低的压缩率:80 IRHD
Rubber, vulcanized or thermoplastic.Determination of compression set.Part 2:At low temperatures
KS M ISO 815-2:2021 硫化橡胶或热塑性橡胶压缩永久变形的测定第2部分:低温下
Rubber, vulcanized or thermoplastic — Determination of compression set — Part 2: At low temperatures
KS M ISO 815-2:2015 硫化橡胶或热塑性橡胶压缩永久变形的测定 第2部分：低温下
Rubber, vulcanized or thermoplastic-Determination of compression set-Part 2:At low temperatures
KS M ISO 815-2-2021 硫化橡胶或热塑性橡胶压缩永久变形的测定第2部分:低温下
Rubber, vulcanized or thermoplastic — Determination of compression set — Part 2: At low temperatures
KS M ISO 815-2:2010 硫化橡胶或热塑性橡胶.压缩永久变形的测定.第2部分:低温条件
이 표준은 가황 또는 열가소성 고무의 저온에서 영구 압축률의 측정 방법에 대하여 규정한다
Rubber, vulcanized or thermoplastic-Determination of compression set-Part 2:At low temperatures
ISO 815-2:2008 硫化橡胶或热塑性橡胶.压缩永久变形的测定.第2部分:低温条件
This part of ISO 815 specifies a method for the determination of the compression set characteristics of vulcanized and thermoplastic rubbers at low
Rubber, vulcanized or thermoplastic - Determination of compression set - Part 2: At low temperatures
NF T46-011-2:2008 硫化橡胶或热塑性橡胶.压缩永久变形的测定.第2部分:低温条件
Rubber, vulcanized or thermoplastic - Determination of compression set - Part 2 : at low temperatures.
NF T46-011-2:2014 硫化橡胶或热塑性橡胶.压缩永久变形的测定.第2部分:低温条件
La présente partie de l'ISO 815 spécifie deux méthodes pour la détermination des caractéristiques de déformation rémanente après compression des
Rubber, vulcanized or thermoplastic - Determination of compression set - Part 2 : at low temperatures
SANS 10815-2:2009 硫化橡胶或热塑性橡胶.压缩永久变形的测定.第2部分:低温条件
Specifies a method for the determination of the compression set characteristics of vulcanized and thermoplastic rubbers at low temperatures
Rubber, vulcanized or thermoplastic - Determination of compression set Part 2: At low temperatures
ISO 815-2:2014 硫化橡胶或热塑性橡胶.压缩永久变形的测定.第2部分:低温条件
This part of ISO 815 specifies two methods for the determination of the compression set characteristics of vulcanized and thermoplastic rubbers at low
Rubber, vulcanized or thermoplastic - Determination of compression set - Part 2: At low temperatures
KS M ISO 815-1:2021 硫化橡胶或热塑性橡胶压缩永久变形的测定第1部分:室温或高温下
Rubber, vulcanized or thermoplastic —Determination of compression set —Part 1: At ambient or elevated temperatures
KS M ISO 815-1-2021 硫化橡胶或热塑性橡胶压缩永久变形的测定第1部分:室温或高温下
Rubber, vulcanized or thermoplastic —Determination of compression set —Part 1: At ambient or elevated temperatures
BS ISO 815-2:2014 硫化橡胶或热塑性橡胶.压缩永久变形的测定.低温条件
Rubber, vulcanized or thermoplastic. Determination of compression set. At low temperatures
BS ISO 815-2:2009 硫化橡胶或热塑性橡胶 压缩永久变形的测定 低温条件
Rubber, vulcanized or thermoplastic. Determination of compression set. At low temperatures
BS ISO 815-2:2008 硫化橡胶或热塑性橡胶.压缩永久变形的测定.低温条件
Rubber, vulcanized or thermoplastic - Determination of compression set - At low temperatures
GB/T 7759.2-2014 硫化橡胶或热塑性橡胶 压缩永久变形的测定 第2部分:在低温条件下
GB/T 7759的本部分规定了在低温条件下测定硫化橡胶或热塑性橡胶压缩永久变形性能的试验方法。本方法用于测量硬度在10 IRHD~95 IRHD范围内的橡胶在规定的温度和压缩率(通常为25%)条件下,经持续压缩后保持其弹性的能力。当橡胶硬度大于80 IRHD时,应选用较低的压缩率:80 IRHD
Rubber, vulcanized or thermoplastic.Determination of compression set.Part 2:At low temperatures
KS M ISO 815-2:2021 硫化橡胶或热塑性橡胶压缩永久变形的测定第2部分:低温下
Rubber, vulcanized or thermoplastic — Determination of compression set — Part 2: At low temperatures
KS M ISO 815-2:2015 硫化橡胶或热塑性橡胶压缩永久变形的测定 第2部分：低温下
Rubber, vulcanized or thermoplastic-Determination of compression set-Part 2:At low temperatures
KS M ISO 815-2-2021 硫化橡胶或热塑性橡胶压缩永久变形的测定第2部分:低温下
Rubber, vulcanized or thermoplastic — Determination of compression set — Part 2: At low temperatures
KS M ISO 815-2:2010 硫化橡胶或热塑性橡胶.压缩永久变形的测定.第2部分:低温条件
이 표준은 가황 또는 열가소성 고무의 저온에서 영구 압축률의 측정 방법에 대하여 규정한다
Rubber, vulcanized or thermoplastic-Determination of compression set-Part 2:At low temperatures
ISO 815-2:2008 硫化橡胶或热塑性橡胶.压缩永久变形的测定.第2部分:低温条件
This part of ISO 815 specifies a method for the determination of the compression set characteristics of vulcanized and thermoplastic rubbers at low
Rubber, vulcanized or thermoplastic - Determination of compression set - Part 2: At low temperatures
NF T46-011-2:2008 硫化橡胶或热塑性橡胶.压缩永久变形的测定.第2部分:低温条件
Rubber, vulcanized or thermoplastic - Determination of compression set - Part 2 : at low temperatures.
NF T46-011-2:2014 硫化橡胶或热塑性橡胶.压缩永久变形的测定.第2部分:低温条件
La présente partie de l'ISO 815 spécifie deux méthodes pour la détermination des caractéristiques de déformation rémanente après compression des
Rubber, vulcanized or thermoplastic - Determination of compression set - Part 2 : at low temperatures
SANS 10815-2:2009 硫化橡胶或热塑性橡胶.压缩永久变形的测定.第2部分:低温条件
Specifies a method for the determination of the compression set characteristics of vulcanized and thermoplastic rubbers at low temperatures
Rubber, vulcanized or thermoplastic - Determination of compression set Part 2: At low temperatures
ISO 815-2:2014 硫化橡胶或热塑性橡胶.压缩永久变形的测定.第2部分:低温条件
This part of ISO 815 specifies two methods for the determination of the compression set characteristics of vulcanized and thermoplastic rubbers at low
Rubber, vulcanized or thermoplastic - Determination of compression set - Part 2: At low temperatures
KS M ISO 815-1:2021 硫化橡胶或热塑性橡胶压缩永久变形的测定第1部分:室温或高温下
Rubber, vulcanized or thermoplastic —Determination of compression set —Part 1: At ambient or elevated temperatures
KS M ISO 815-1-2021 硫化橡胶或热塑性橡胶压缩永久变形的测定第1部分:室温或高温下
Rubber, vulcanized or thermoplastic —Determination of compression set —Part 1: At ambient or elevated temperatures
编辑：北检院编辑部
