机电开关（旋转、成列直插封装式、钮子、按钮、微动开关）检测

DLA DSCC-DWG-89114 REV D-2002 直径1.180英寸按钮式旋转开关

This drawing describes the requirements for a rotary switch supplied to the requirements of MIL-PRF-3786,type SR04, except as noted herein

SWITCH, ROTARY, 1.180 INCH DIAMETER, PUSH TO TURN

NF L58-155:1964 飞机电气开关装置 密封按钮开关

Switchgear for aircraft. Sealed push-button switches.

KS C 4517-1978 按钮式开关

이 규격은 주파수 60Hz의 교류 600V 또는 직류 250V 이하의 전로에 사용되는제어용

Button control switches

JB/T 3907-1999 按钮开关

　　本标准规定了按钮开关通用的基本规则和要求，包括定义、特性、正常工作条件、安装条件、结构和性能要求、特性和性能验证等。 本标准适用于交流 50（或60）Hz、电压至 660V、直流电压至 440V 电路中作为控制、信号、连锁等用途的按钮开关

power switch button

JB/T 3907-2008 机床电器 按钮开关

本标准规定了按钮开关的型式、参数、技术要求、试验方法、检验规则等。 本标准适用于在交流50Hz或60Hz、额定电压至660V，直流额定电压值440V的电路中，作控制、信号、联锁等用途的按钮开关

Machine tool electric apparatus. Push-button switches

TS 3316-1979 按钮开关

PUSH — BUTTON SWITCHES

DS/IEC 341-3:1981 按钮开关.第3部分:多单元型按钮开关

Push-button switches. Part 3: Push-button switches of the multi-cell type

IEC 60341-3:1978 按钮开关.第3部分:多单元型按钮开关

Push-button switches. Part 3: Push-button switches of the multi-cell type

NF L58-525:1966 飞机开关装置.三极按钮断路开关

SWITCHGEAR FOR AIRCRAFT. TRIPLE POLE PUSH-BUTTON OPERATED CIRCUIT-BREAKER.

GOST R 50320-1992 电子设备在使用的机电式开关.按钮开关分规范

Electromechanical switches for use in electronic equipment. Sectional specification for pushbutton switches

IS 4794 Pt.2-1986 按钮开关规范 第2部分按钮开关 类型 1

This standard (Part 2 ) covers requirements for push-button switches ( Type 1 ) used in consumer electronics like wave band change switches in mains

Specification for Push Button Switches Part 2 Push Button Switch Types 1

DLA MIL-PRF-22885/105 C-2010 开关，按钮，发光，插入式，开关模块，用于 2PDT，4PDT

SWITCH, PUSHBUTTON, ILLUMINATED, PLUG-IN, SWITCH MODULE FOR, 2PDT, 4PDT

DLA MIL-DTL-5423 D-2002 (按钮开关,断路开关,和旋转开关组件)密封防水防尘靴的一般规范

This specification covers the general requirements for molded silicone rubber boots which can be used on component parts such as toggle

BOOTS, DUST AND WATER SEAL (FOR TOGGLE AND PUSH-BUTTON SWITCHES, CIRCUIT BREAKERS, AND ROTARY-ACTUATED PARTS), GENERAL SPECIFICATION FOR

KS C 4517-1978(2015 按钮控制开关

Button control switches

GB/T 16514-1996 电子设备用机电开关 第5部分;按钮开关分规范

本规范适用于有质量评定的机电开关门类中的按钮开关分门类。本规范规定的按钮开关，其额定电压小于300V，额定电流小于5A（d.c.或r.m.s.）。本规范适用于装有微动开关的按钮开关，微动开关直接控制负载电流。还适用于单单元和多单元按钮开关。 不适用于键盘和辅助键盘。 本规范的目的

Electromechanical switches for use in electronic equipment--Part 5: Sectional specification for pushbutton switches

DLA DSCC-DWG-89114 REV D-2002 直径1.180英寸按钮式旋转开关

This drawing describes the requirements for a rotary switch supplied to the requirements of MIL-PRF-3786,type SR04, except as noted herein

SWITCH, ROTARY, 1.180 INCH DIAMETER, PUSH TO TURN

NF L58-155:1964 飞机电气开关装置 密封按钮开关

Switchgear for aircraft. Sealed push-button switches.

KS C 4517-1978 按钮式开关

이 규격은 주파수 60Hz의 교류 600V 또는 직류 250V 이하의 전로에 사용되는제어용

Button control switches

JB/T 3907-1999 按钮开关

　　本标准规定了按钮开关通用的基本规则和要求，包括定义、特性、正常工作条件、安装条件、结构和性能要求、特性和性能验证等。 本标准适用于交流 50（或60）Hz、电压至 660V、直流电压至 440V 电路中作为控制、信号、连锁等用途的按钮开关

power switch button

JB/T 3907-2008 机床电器 按钮开关

本标准规定了按钮开关的型式、参数、技术要求、试验方法、检验规则等。 本标准适用于在交流50Hz或60Hz、额定电压至660V，直流额定电压值440V的电路中，作控制、信号、联锁等用途的按钮开关

Machine tool electric apparatus. Push-button switches

TS 3316-1979 按钮开关

PUSH — BUTTON SWITCHES

DS/IEC 341-3:1981 按钮开关.第3部分:多单元型按钮开关

Push-button switches. Part 3: Push-button switches of the multi-cell type

IEC 60341-3:1978 按钮开关.第3部分:多单元型按钮开关

Push-button switches. Part 3: Push-button switches of the multi-cell type

NF L58-525:1966 飞机开关装置.三极按钮断路开关

SWITCHGEAR FOR AIRCRAFT. TRIPLE POLE PUSH-BUTTON OPERATED CIRCUIT-BREAKER.

GOST R 50320-1992 电子设备在使用的机电式开关.按钮开关分规范

Electromechanical switches for use in electronic equipment. Sectional specification for pushbutton switches

IS 4794 Pt.2-1986 按钮开关规范 第2部分按钮开关 类型 1

This standard (Part 2 ) covers requirements for push-button switches ( Type 1 ) used in consumer electronics like wave band change switches in mains

Specification for Push Button Switches Part 2 Push Button Switch Types 1

DLA MIL-PRF-22885/105 C-2010 开关，按钮，发光，插入式，开关模块，用于 2PDT，4PDT

SWITCH, PUSHBUTTON, ILLUMINATED, PLUG-IN, SWITCH MODULE FOR, 2PDT, 4PDT

DLA MIL-DTL-5423 D-2002 (按钮开关,断路开关,和旋转开关组件)密封防水防尘靴的一般规范

This specification covers the general requirements for molded silicone rubber boots which can be used on component parts such as toggle

BOOTS, DUST AND WATER SEAL (FOR TOGGLE AND PUSH-BUTTON SWITCHES, CIRCUIT BREAKERS, AND ROTARY-ACTUATED PARTS), GENERAL SPECIFICATION FOR

KS C 4517-1978(2015 按钮控制开关

Button control switches

GB/T 16514-1996 电子设备用机电开关 第5部分;按钮开关分规范

本规范适用于有质量评定的机电开关门类中的按钮开关分门类。本规范规定的按钮开关，其额定电压小于300V，额定电流小于5A（d.c.或r.m.s.）。本规范适用于装有微动开关的按钮开关，微动开关直接控制负载电流。还适用于单单元和多单元按钮开关。 不适用于键盘和辅助键盘。 本规范的目的

Electromechanical switches for use in electronic equipment--Part 5: Sectional specification for pushbutton switches