GJB 6564-2008 全球定位系统(GPS)接收机检定规程
本标准规定了军用GPS接收机的技术要求、检定条件、检定项目、检定方法及检定数据的处理和检定周期。 本标准适用于新制造、使用中和修理后的测量型GPS接收机和导航型GPS接收机
Verification regulation for Global Positioning System(GPS) receiver
GB/T 15527-1995 船用全球定位系统(GPS)接收机通用技术条件
本标准规定了船用全球定位系统(GPS)接收机的技术要求、试验方法和检验规则以及标志、包装、运输、贮存。 本标准适用于船用导航型全球定位系统(GPS)接收机(以下简称接收机),是制定产品标准的依据
General specification for marine GPS receiver
JJF 1347-2012 全球定位系统(GPS)接收机(测地型)型式评价大纲
本大纲适用于全球定位系统(GPS)接收机(测地型)的型式评价
Program of Pattern Evaluation for Global Positioning System (GPS) Receivers (Geodesic)
JJF 1118-2004 全球定位系统(GPS)接收机(测地型和导航型)校准规范
Calibration Specification for Global Positioning System (GPS) Receiver
BS EN 61108-1:2003 全球导航卫星系统(GNSS).全球定位系统(GPS).接收机设备.性能标准、测试方法和要求的测试结果
This part of IEC 61108 specifies the minimum performance standards, methods of testing and required test results for GPS shipborne receiver equipment
Global navigation satellite systems (GNSS) - Global positioning system (GPS) - Receiver equipment - Performance standards, methods of testing and required test results
JT/T 219-1996 船用通信、导航设备安装、使用、维护、修理技术要求 全球定位系统(GPS)接收机
本标准规定了船用全球定位系统(GPS)接收机的安装、使用、维护、修理技术要求。 本标准符合JT/ T8100.1《船 用通信、导航设备的安装、使用、维护、修理技术要求 总则》所规定的适用范围
Requirements for installation,operation,maintenance and repair of marine navigation and communications equipment Global positioning system (GPS) receiver
JT/T 219-2015 船用通信、导航设备的安装、使用、维护、维修技术要求 全球定位系统(GPS)接收机
本标准规定了船用全球定位系统(GPS)接收机(以下简称接收机)的安装、使用、维护、修理技术要求。 本标准适用于海洋各航区及内河所有民用船舶和海上设施上装备的GPS接收机
Technique requirements for installation, operation, maintenance and repair of marine navigation and communications equipment.Global Positioning System (GPS) receiver
CH 8016-1995 全球定位系统(GPS)测量型接收机检定规程
本标准规定了全球定位系统测量型接收机的检定目的、检定项目和检定方法。 GPP S 接 收机检验的目的是了解仪器性能、工作特性及其可能达到的精度水平。它是制定GPS作业计划的依据,也是GPS定位测量顺利完成的重要保证。本规程适用于各种精度测量型GPS接收机的验收与作业前的检验。作业单位可根据
Specification for Check off and Test of GPS Receiver of Surveying Model
IEC 61108-1:1996 全球导航卫星系统(GNSS) 第1部分:全球定位系统(GPS) 接收机设备 性能标准、测试方法和要求的测试结果
Global navigation satellite systems (GNSS) - Part 1: Global positioning system (GPS) - Receiver equipment - Performance standards, methods of testing and required test results
NF C46-812:1997 全球导航卫星系统(GNSS).第1部分:全球定位系统(GPS).接收机设备.性能标准、试验方法和要求的试验结果
Global navigation satellite systems (GNSS). Part 1 : global positioning system (GPS). Receiver equipment. Performance standards, methods of testing and required test results.
GJB/J 3073-1997 全球定位系统(GPS)时间频率接收机检定规程
Global Positioning System (GPS) time and frequency receiver calibration procedures
SAE ARINC743-1990 机载全球定位系统接收器
This standard provides design guidance for the development of GPS sensors for airline use. It describes the operational capability of the GPS receiver
AIRBORNE GLOBAL POSITIONING SYSTEM RECEIVER
IEC 61108-1:2003 海上导航和线电通信设备和系统.全球导航卫星系统(GNSS).第1部分:全球定位系统(GPS).接收机设备.性能标准、测试方法和要求的测试结果
Specifies the minimum performance standards, methods of testing and required test results for GPS shipborne receiver equipment, based on the relevant
Maritime navigation and radiocommunication equipment and systems - Global navigation satellite systems (GNSS) - Part 1: Global positioning system (GPS); Receiver equipment; Performance standards, methods of testing and required test results
DIN EN 61108-1:2004 海上导航和线电通信设备和系统.全球导航卫星系统(GNSS).第1部分:全球定位系统(GPS).接收机设备.性能标准、测试方法和要求的测试结果
This part 1 of the multi-part standard IEC 61108 specifies the minimum performance standards, methods of testing and required test results for GPS
Maritime navigation and radiocommunication equipment and systems - Global navigation satellite systems (GNSS) - Part 1: Global positioning system (GPS) - Receiver equipment - Performance standards, methods of testing and required test results (IEC 61108-1
GJB/J 3073-1997(XG1-2015 全球定位系统(GPS)时间频率接收机检定规程 修改单1-2015
Global Positioning System (GPS) Time and Frequency Receiver Calibration Regulations Modification Sheet 1-2015
GJB 6564-2008 全球定位系统(GPS)接收机检定规程
本标准规定了军用GPS接收机的技术要求、检定条件、检定项目、检定方法及检定数据的处理和检定周期。 本标准适用于新制造、使用中和修理后的测量型GPS接收机和导航型GPS接收机
Verification regulation for Global Positioning System(GPS) receiver
GB/T 15527-1995 船用全球定位系统(GPS)接收机通用技术条件
本标准规定了船用全球定位系统(GPS)接收机的技术要求、试验方法和检验规则以及标志、包装、运输、贮存。 本标准适用于船用导航型全球定位系统(GPS)接收机(以下简称接收机),是制定产品标准的依据
General specification for marine GPS receiver
JJF 1347-2012 全球定位系统(GPS)接收机(测地型)型式评价大纲
本大纲适用于全球定位系统(GPS)接收机(测地型)的型式评价
Program of Pattern Evaluation for Global Positioning System (GPS) Receivers (Geodesic)
JJF 1118-2004 全球定位系统(GPS)接收机(测地型和导航型)校准规范
Calibration Specification for Global Positioning System (GPS) Receiver
BS EN 61108-1:2003 全球导航卫星系统(GNSS).全球定位系统(GPS).接收机设备.性能标准、测试方法和要求的测试结果
This part of IEC 61108 specifies the minimum performance standards, methods of testing and required test results for GPS shipborne receiver equipment
Global navigation satellite systems (GNSS) - Global positioning system (GPS) - Receiver equipment - Performance standards, methods of testing and required test results
JT/T 219-1996 船用通信、导航设备安装、使用、维护、修理技术要求 全球定位系统(GPS)接收机
本标准规定了船用全球定位系统(GPS)接收机的安装、使用、维护、修理技术要求。 本标准符合JT/ T8100.1《船 用通信、导航设备的安装、使用、维护、修理技术要求 总则》所规定的适用范围
Requirements for installation,operation,maintenance and repair of marine navigation and communications equipment Global positioning system (GPS) receiver
JT/T 219-2015 船用通信、导航设备的安装、使用、维护、维修技术要求 全球定位系统(GPS)接收机
本标准规定了船用全球定位系统(GPS)接收机(以下简称接收机)的安装、使用、维护、修理技术要求。 本标准适用于海洋各航区及内河所有民用船舶和海上设施上装备的GPS接收机
Technique requirements for installation, operation, maintenance and repair of marine navigation and communications equipment.Global Positioning System (GPS) receiver
CH 8016-1995 全球定位系统(GPS)测量型接收机检定规程
本标准规定了全球定位系统测量型接收机的检定目的、检定项目和检定方法。 GPP S 接 收机检验的目的是了解仪器性能、工作特性及其可能达到的精度水平。它是制定GPS作业计划的依据,也是GPS定位测量顺利完成的重要保证。本规程适用于各种精度测量型GPS接收机的验收与作业前的检验。作业单位可根据
Specification for Check off and Test of GPS Receiver of Surveying Model
IEC 61108-1:1996 全球导航卫星系统(GNSS) 第1部分:全球定位系统(GPS) 接收机设备 性能标准、测试方法和要求的测试结果
Global navigation satellite systems (GNSS) - Part 1: Global positioning system (GPS) - Receiver equipment - Performance standards, methods of testing and required test results
NF C46-812:1997 全球导航卫星系统(GNSS).第1部分:全球定位系统(GPS).接收机设备.性能标准、试验方法和要求的试验结果
Global navigation satellite systems (GNSS). Part 1 : global positioning system (GPS). Receiver equipment. Performance standards, methods of testing and required test results.
GJB/J 3073-1997 全球定位系统(GPS)时间频率接收机检定规程
Global Positioning System (GPS) time and frequency receiver calibration procedures
SAE ARINC743-1990 机载全球定位系统接收器
This standard provides design guidance for the development of GPS sensors for airline use. It describes the operational capability of the GPS receiver
AIRBORNE GLOBAL POSITIONING SYSTEM RECEIVER
IEC 61108-1:2003 海上导航和线电通信设备和系统.全球导航卫星系统(GNSS).第1部分:全球定位系统(GPS).接收机设备.性能标准、测试方法和要求的测试结果
Specifies the minimum performance standards, methods of testing and required test results for GPS shipborne receiver equipment, based on the relevant
Maritime navigation and radiocommunication equipment and systems - Global navigation satellite systems (GNSS) - Part 1: Global positioning system (GPS); Receiver equipment; Performance standards, methods of testing and required test results
DIN EN 61108-1:2004 海上导航和线电通信设备和系统.全球导航卫星系统(GNSS).第1部分:全球定位系统(GPS).接收机设备.性能标准、测试方法和要求的测试结果
This part 1 of the multi-part standard IEC 61108 specifies the minimum performance standards, methods of testing and required test results for GPS
Maritime navigation and radiocommunication equipment and systems - Global navigation satellite systems (GNSS) - Part 1: Global positioning system (GPS) - Receiver equipment - Performance standards, methods of testing and required test results (IEC 61108-1
GJB/J 3073-1997(XG1-2015 全球定位系统(GPS)时间频率接收机检定规程 修改单1-2015
Global Positioning System (GPS) Time and Frequency Receiver Calibration Regulations Modification Sheet 1-2015
编辑:北检院编辑部















