混凝土试块检测

DS 423.32:1984 混凝土试验．硬化混凝土．块芯抗弯试验

Denne standard beskriver fremgangsmåden ved bestemmelse af den kraft, som kræves for i et færdigt objekt at afbrække en betoncylinderkærne med mål

Testing of concrete. Hardened concrete. Core bending test

INDITECNOR 30-154ch-1955 混凝土块的测试

Las prescripciones que establece esta norma se aplicarán a los bloques de hormigón destinados a las construcciones

BS EN 13880-12:2003 热用接缝密封胶.粘结试验用混凝土试验块生产的试验方法(配方法)

This European Standard describes a method for the manufacture of concrete test blocks for joint sealant bond testing. The requirements

Hot applied joint sealants - Test method for the manufacture of concrete test blocks for bond testing (recipe methods)

DIN EN 13880-12:2003 热用密封胶.第12部分:粘结试验中混凝土试验块制造的试验方法(配方法)

This European Standard describes a method for the manufacture of concrete test blocks for joint sealant bond testing. The requirements

Hot applied joint sealants - Part 12: Test method for the manufacture of concrete test blocks for bond testing (recipe methods); German version EN 13880-12:2003

NF P98-880-12*NF EN 13880-12:2004 热用密封胶 第12部分：粘结试验中混凝土试验块制造的试验方法（配方法）

Hot applied joint sealants - Part 12 : test methods for the manufacture of concrete test blocks for bond testing (recipe methods)

EN 13880-12:2003 热接合密封剂.第12部分:粘结试验中混凝土试验块制造的试验方法(配方法)

This European Standard describes a method forThe manufacture of concrete test blocks for joint sealant bond testing

Hot applied joint sealants - Part 12: Test method for the manufacture of concrete test blocks for bond testing (recipe methods)

GB/T 4111-2013 混凝土砌块和砖试验方法

本标准规定了混凝土砌块和混凝土多孔(空心)砖的术语和定义、尺寸偏差、外观质量、抗压强度、抗折强度、块体密度、空心率、含水率、吸水率、相对含水率、干燥收缩值、软化系数、碳化系数、抗冻性和抗渗性的试验方法。本标准适用于建筑工程用的混凝土小型空心砌块、混凝土实心砌块和混凝土多孔(空心)砖(以下统称块材

Test methods for the concrete block and brick

SS 78 Pt.A8-1987 混凝土测试．第A8部分：用新拌混凝土制作测试块的方法

This Standard describes a method for making test cubes of nominal sizes 100 mm and 150 mm made out of fresh concrete. The method applies to plain

Testing Concrete Part A8 : Method For Making Test Cubes From Fresh Concrete

DIN EN 1338:2003 铺路混凝土砌块.要求和试验方法

The scope of this standard is to specify materials, properties, requirements and methods of testing for precast concrete paving blocks

Concrete paving blocks - Requirements and test methods; German version EN 1338:2003

GB/T 4111-1997 混凝土小型空心砌块试验方法

本标准规定了混凝土小型空心砌块的尺寸、外观、抗压强度、抗折强度、块体密度、空心率、含水率、吸水率、相对含水率、干燥收缩、软化系数、碳化系数、抗冻性和抗渗性的试验方法。本标准适用于墙体用的以各种混凝土制成的小型空心砌块（以下简称砌块

Test methods for the small concrete hollow block

TIS 109-1974 混凝土砌块的取样和试验标准

Standard for sampling and testing concrete masonry units

SS 78 Pt.A13-1987 混凝土测试． 第13部分：细料混凝土立方体试块的制作和养护方法

This Singapore Standard describes the method for making and curing 150 mm test cubes of fresh no-fines concrete made with aggregate having a nominal

Testing Concrete Part A13: Method For Making And Curing No-fines Test Cubes

BS 1881-113:2011 混凝土试验.第113部分:细料混凝土立方体试块的制备和养护方法

This part of BS 1881 describes a method for making adn curing 150 mm test cubes of fresh no-fines concrete made with aggregate having a nominal

Testing concrete. Method for making and curing no-fines test cubes

BS 1881-113:1983 混凝土试验.第113部分:细料混凝土立方体试块的制备和养护方法

Gives the method for making and curing 150 mm test cubes of fresh no-fines concrete made with aggregates of 40 mm nominal maximum size or less

Testing concrete - Method for making and curing no-fines test cubes

DIN EN 1338 Corrigendum 1:2006 铺路用混凝土砌块. 试验方法和要求. 英文版本DIN EN 1339: 2003. 08勘误表1

Concrete paving blocks - Requirements and test methods Corrigendum 1 to English version of DIN EN 1338:2003-08

DS 423.32:1984 混凝土试验．硬化混凝土．块芯抗弯试验

Denne standard beskriver fremgangsmåden ved bestemmelse af den kraft, som kræves for i et færdigt objekt at afbrække en betoncylinderkærne med mål

Testing of concrete. Hardened concrete. Core bending test

INDITECNOR 30-154ch-1955 混凝土块的测试

Las prescripciones que establece esta norma se aplicarán a los bloques de hormigón destinados a las construcciones

BS EN 13880-12:2003 热用接缝密封胶.粘结试验用混凝土试验块生产的试验方法(配方法)

This European Standard describes a method for the manufacture of concrete test blocks for joint sealant bond testing. The requirements

Hot applied joint sealants - Test method for the manufacture of concrete test blocks for bond testing (recipe methods)

DIN EN 13880-12:2003 热用密封胶.第12部分:粘结试验中混凝土试验块制造的试验方法(配方法)

This European Standard describes a method for the manufacture of concrete test blocks for joint sealant bond testing. The requirements

Hot applied joint sealants - Part 12: Test method for the manufacture of concrete test blocks for bond testing (recipe methods); German version EN 13880-12:2003

NF P98-880-12*NF EN 13880-12:2004 热用密封胶 第12部分：粘结试验中混凝土试验块制造的试验方法（配方法）

Hot applied joint sealants - Part 12 : test methods for the manufacture of concrete test blocks for bond testing (recipe methods)

EN 13880-12:2003 热接合密封剂.第12部分:粘结试验中混凝土试验块制造的试验方法(配方法)

This European Standard describes a method forThe manufacture of concrete test blocks for joint sealant bond testing

Hot applied joint sealants - Part 12: Test method for the manufacture of concrete test blocks for bond testing (recipe methods)

GB/T 4111-2013 混凝土砌块和砖试验方法

本标准规定了混凝土砌块和混凝土多孔(空心)砖的术语和定义、尺寸偏差、外观质量、抗压强度、抗折强度、块体密度、空心率、含水率、吸水率、相对含水率、干燥收缩值、软化系数、碳化系数、抗冻性和抗渗性的试验方法。本标准适用于建筑工程用的混凝土小型空心砌块、混凝土实心砌块和混凝土多孔(空心)砖(以下统称块材

Test methods for the concrete block and brick

SS 78 Pt.A8-1987 混凝土测试．第A8部分：用新拌混凝土制作测试块的方法

This Standard describes a method for making test cubes of nominal sizes 100 mm and 150 mm made out of fresh concrete. The method applies to plain

Testing Concrete Part A8 : Method For Making Test Cubes From Fresh Concrete

DIN EN 1338:2003 铺路混凝土砌块.要求和试验方法

The scope of this standard is to specify materials, properties, requirements and methods of testing for precast concrete paving blocks

Concrete paving blocks - Requirements and test methods; German version EN 1338:2003

GB/T 4111-1997 混凝土小型空心砌块试验方法

本标准规定了混凝土小型空心砌块的尺寸、外观、抗压强度、抗折强度、块体密度、空心率、含水率、吸水率、相对含水率、干燥收缩、软化系数、碳化系数、抗冻性和抗渗性的试验方法。本标准适用于墙体用的以各种混凝土制成的小型空心砌块（以下简称砌块

Test methods for the small concrete hollow block

TIS 109-1974 混凝土砌块的取样和试验标准

Standard for sampling and testing concrete masonry units

SS 78 Pt.A13-1987 混凝土测试． 第13部分：细料混凝土立方体试块的制作和养护方法

This Singapore Standard describes the method for making and curing 150 mm test cubes of fresh no-fines concrete made with aggregate having a nominal

Testing Concrete Part A13: Method For Making And Curing No-fines Test Cubes

BS 1881-113:2011 混凝土试验.第113部分:细料混凝土立方体试块的制备和养护方法

This part of BS 1881 describes a method for making adn curing 150 mm test cubes of fresh no-fines concrete made with aggregate having a nominal

Testing concrete. Method for making and curing no-fines test cubes

BS 1881-113:1983 混凝土试验.第113部分:细料混凝土立方体试块的制备和养护方法

Gives the method for making and curing 150 mm test cubes of fresh no-fines concrete made with aggregates of 40 mm nominal maximum size or less

Testing concrete - Method for making and curing no-fines test cubes

DIN EN 1338 Corrigendum 1:2006 铺路用混凝土砌块. 试验方法和要求. 英文版本DIN EN 1339: 2003. 08勘误表1

Concrete paving blocks - Requirements and test methods Corrigendum 1 to English version of DIN EN 1338:2003-08