ANSI/AAMI NS28-1988 颅内压力监测装置
Establishes minimum labeling, safety, and performance requirements for intracranial pressure monitoring devices, whether percutaneous, fully
Intracranial Pressure Monitoring Devices
MNOSZ 14702-1954 手术器具．颅骨测量仪
ASTM F700-93(2002 颅内动脉卡箍及仪器的保养及管理
1.1 This practice covers recommended procedures for handling of neurosurgical intracranial aneurysm clips and the clip appliers (instruments).
Standard Practice for Care and Handling of Intracranial Aneurysm Clips and Instruments
SAE J1589-1998 内燃机活塞环检测测量原则
This SAE Standard defines the measuring principles to be used for measuring piston rings. It applies to piston rings up to and including 200 mm
Internal Combustion Engines Piston Rings Inspection Measuring Principles
JJF 1693-2018 颅内压监护仪校准规范
Calibration Specification for Intracranial Pressure Monitors
T/STIC 110083-2022 颅内血流导向密网支架
本文件规定了颅内血流导向密网支架的技术要求、检验方法、检验规则、标志、标签、使用说明书、包装、运输和储存的要求。 本文件适用于治疗颅内动脉瘤的血流导向密网支架，包括支架及配套使用的输送系统。本文件不包含用于输送支架的通路器械（如微导管）及其他配套器械
Intracranial Flow Diverter Stent
BS ISO 6621-2:2020 内燃机 活塞环 检验测量规则
Tracked Changes. Internal combustion engines. Piston rings. Inspection measuring principles
BS ISO 18669-2:2020 内燃机 活塞销 检验测量原理
Tracked Changes. Internal combustion engines. Piston pins. Inspection measuring principles
BS ISO 6621-2:2003 内燃机.活塞环.检验测量规则
This part of ISO 6621 specifies the principles to be used in the measuring for inspection purposes of piston rings for both reciprocating internal
Internal combustion engines - Piston rings - Inspection measuring principles
BS ISO 6621-2:2004 内燃机.活塞环.检验测量规则
This part of ISO 6621 specifies the principles to be used in the measuring for inspection purposes of piston rings for both reciprocating internal
Internal combustion engines - Piston rings - Inspection measuring principles
BS ISO 18669-2:2005 内燃机.活塞销.检验测量原理
ISO 18669-2:2004 defines the measuring principles to be used for measuring piston pins; it applies to piston pins from 8 mm up to and including 100 mm
Internal combustion engines - Pistons pins - Inspection measuring principles
0 内燃机．活塞环．检查测量原则
Zpracovatel: BUZULUK Komárov, a. s., I?O 45148414, Ji?í Hejtmánek Pracovník ?eského normaliza?ního institutu: Ing. Hana Floriánov
T/CAMDI 070-2021 增材制造聚醚醚酮（PEEK）个性化颅颌面植入器械
本标准规定了以增材制造加工技术为主的PEEK个性化颅颌面植入器械的原材料、质量评价、检验方法、质量控制、制造、灭菌、包装、随访等信息的要求。 本标准适用于通过外科手术植入颅颌面骨骼，用于颅颌面骨骼缺损修复、外形修整、固位与稳定的增材制造PEEK植入式医疗器械设计制造规范。 本标准涵盖了由原料
DOD A-A-54650-1992 外科开颅器装置
This commercial item description covers an air powered neurosurgical craniotome set used for excision of a part of the skull
CRANIOTOME SET, NEUROSURGICAL AIR POWERED
T/CVMA 18-2020 塞内卡病毒荧光RT-PCR检测方法
本文件规定了塞内卡病毒荧光RT-PCR检测时的仪器设备、样品采集保存和运输、荧光PCR操作程序、结果判定、注意事项。 本文件适用于猪水泡皮、EDTA抗凝全血、脾脏等组织及猪制品中塞内卡病毒的核酸检测
MNOSZ 15538-1953 手术器具．颅骨皮切割钳
ASTM F700-93(2014 颅内动脉瘤夹和仪器的护理和操作的标准实施规程
1.1x00a0;This practice covers recommended procedures
Standard Practice for Care and Handling of Intracranial Aneurysm Clips and Instruments
ASTM F700-93(2008 颅内动脉卡箍及仪器的保养及管理的标准实施规程
1.1 This practice covers recommended procedures for handling of neurosurgical intracranial aneurysm clips and the clip appliers
Standard Practice for Care and Handling of Intracranial Aneurysm Clips and Instruments
ASTM F700-93(2022 颅内动脉瘤夹和仪器的护理和处理的标准实施规程
Standard Practice for Care and Handling of Intracranial Aneurysm Clips and Instruments
NF S94-302:2009 神经外科植入物.颅内动脉瘤自闭夹
Neurosurgical implants - Self-closing intracranial aneurysm clips.
BS EN ISO 9713:2009 神经外科植入物.颅内动脉瘤自闭夹
Neurosurgical implants - Self-closing intracranial aneurysm clips
KS P ISO 9713:2009 神经外科植入物.颅内动脉瘤自闭夹
이 표준은 영구적인 두개(頭蓋) 내 이식용 자폐성 동맥류 클립의 특성을 묘사하며 표기, 포
Neurosurgical implants－Self-closing intracranial aneurysm clips
ISO 9713:2002 神经外科植入物.颅内动脉瘤自闭夹
This International Standard describes characteristics of self-closing aneurysm clips intended for permanent intracranial implantation and specifies
Neurosurgical implants - Self-closing intracranial aneurysm clips
EN ISO 9713:2022 神经外科植入物.自锁颅内动脉瘤夹钳
This document establishes the characteristics of self-closing aneurysm clips intended for permanent intracranial implantation and specifies
Neurosurgical implants - Self-closing intracranial aneurysm clips (ISO 9713:2022)
EN ISO 9713:2009 神经外科植入物.自锁颅内动脉瘤夹钳
This International Standard describes characteristics of self-closing aneurysm clips intended for permanentintracranial implantation and specifies
Neurosurgical implants - Self-closing intracranial aneurysm clips (ISO 9713:2002)
ISO 9713:1990 神经外科植入物.颅内动脉瘤自闭合剪
Neurosurgical implants; self-closing intracranial aneurysm clips
DIN 40740:1991 铅酸蓄电池.固定电池，附件.陶瓷漏斗形栓塞，陶瓷栓塞，电解液面指示器
Ceramic-funnel-plugs are used, to refill through the funnel and stop re-ignition. Ceramic-plugs are used in cells of higher capacity
Lead-acid traction batteries; stationary batteries, accessories; ceramic-funnel-plug, ceramic-plug, electrolyt-level-indicator
YY/T 1446-2016 医用内窥镜内窥镜器械掌式器械
本标准规定了掌式器械的范围、术语和定义、要求、试验方法。 本标准适用于内窥镜手术所使用的掌式器械
Medical endoscopes.Endotherapy device.Palmate retractor
ISO 9713:2022 神经外科植入物.自动闭合颅内动脉瘤夹
Neurosurgical implants — Self-closing intracranial aneurysm clips
KS P ISO 9713-2009(2019 神经外科植入物-自动闭合颅内动脉瘤夹
Neurosurgical implants－Self-closing intracranial aneurysm clips
编辑：北检院编辑部
