DIN EN 14705:2005 热交换器.湿冷却塔热性能的评价和测量方法
This European Standard specifies requirements, test methods and acceptance tests for thermal performances pumping head verification of wet cooling
Heat exchangers - Method of measurement and evaluation of thermal performances of wet cooling towers; German version EN 14705:2005
EN 14705:2005 热交换器.湿冷却塔热性能的评价和测量方法
This European Standard specifies requirements, test methods and acceptance tests for thermal performances pumping head verification of wet cooling
Heat exchangers - Method of measurement and evaluation of thermal performances of wet cooling towers
NF E38-423*NF EN 14705:2005 热交换器.湿冷却塔热性能的测量和评价方法
Heat exchangers - Method of measurement and evaluation of thermal performances of wet cooling towers.
GOST R EN 14705-2011 热交换器. 湿式冷却塔热性能的测量和评估方法
Heat exchangers. Methods of measurement and evaluation of thermal performances of wet cooling towers
BS EN 14705:2005 热交换器.湿式冷却塔热性能的测量和评定方法
This European Standard specifies requirements, test methods and acceptance tests for thermal performances pumping head verification of wet cooling
Heat exchangers - Method of measurement and evaluation of thermal performances of wet cooling towers
KS P ISO 9360-1-2009(2019 麻醉和呼吸设备人体呼吸气体增湿用热湿交换器第1部分:最小潮气量为250ml的热湿交换器
Anaesthetic and respiratory equipment－Heat and moisture exchangers(HMEs) for humidifying respired gases in humans－ Part 1：HMEs for use with minimum tidal volumes of 250 mL
EN ISO 9360-1:2009 用于加湿人的呼吸气体的热湿交换器(HMEs).第1部分:潮气量最小为250ml的气管造口病热湿交换器
This part of ISO 9360 specifies certain requirements for heat and moisture exchangers (HMEs); including thoseincorporating breathing system filters
Anaesthetic and respiratory equipment - Heat and moisture exchangers (HMEs) for humidifying respired gases in humans - Part 1: HMEs for use with minimum tidal volumes of 250 ml
DL/T 937-2005 热交换器管声脉冲检测技术导则
本标准规定了电站热交换器管的声脉冲检测设备、检测方法及检测结果评定方法。 本标准适用于内径为10mm～50mm、长度不大于60mm的直管、U形管、弯管和盘管的声脉冲检测。其他用途的复合或金属管可参照执行
Technical guide of sonic pulse inspection for tubes of heat exchanger
BS EN ISO 9360-1:2009 麻醉和呼吸设备.加湿人呼吸气体的热湿交换器(HMEs).第1部分:最小呼吸量250 ml的热湿交换器(ISO 9360-1-2000)
This part of ISO 9360 specifies certain requirements for heat and moisture exchangers (HMEs), including those incorporating breathing system filters
Anaesthetic and respiratory equipment - Heat and moisture exchangers (HMEs) for humidifying respired gases in humans -Part 1: HMEs for use with minimum tidal volumes of 250 ml (ISO 9360-1:2000)
DB41/T 1886-2019 绕管式热交换器检验规范
GB/T 151-2014 热交换器
本标准规定了金属制热交换器的通用要求,并规定了管壳式热交换器材料、设计、制造、检验、验收及其安装、使用的要求。本标准的通用要求适用于管壳式热交换器及其他结构型式热交换器,本标准的所有内容适用于管壳式热交换器。本标准适用的设计压力:a) 管壳式热交换器的设计压力不大于35 MPa;b) 其他结构型式
Heat exchangers
NBN-ENV 308-1993 热交换器．空气/空气热交换器和空气/煤气热交换器性能测定的实验程序
Heat exchangers. Test procedures for establishing performance of air to air and flue gases heat recovery devices
ISO 9360-1:2000 麻醉和呼吸设备 用于加湿人的呼吸气体的热湿交换器(HMEs) 第1部分:与250ml最小潮量一起使用的热湿交换器
This part of ISO 9360 specifies certain requirements for heat and moisture exchangers (HMEs), including those incorporating breathing system filters
Anaesthetic and respiratory equipment - Heat and moisture exchangers (HMEs) for humidifying respired gases in humans - Part 1: HMEs for use with minimum tidal volumes of 250 ml
KS P ISO 9360-2-2009(2019 麻醉和呼吸设备人体呼吸气体增湿用热湿交换器第2部分:最小潮气量为250ml气管切开病人用热湿交换器
Anaesthetic and respiratory equipment－Heat and moisture exchangers(HMEs) for humidifying respired gases in humans－Part 2：HMEs for use with tracheostomized patients having minimum tidal volumes of 250
NBN-ENV 305-1993 热交换器．热交换器性能的确定，各种型号热交换器性能测定的总实验程序
Heat exchangers. Definitions of performance of heat exchangers and the general test procedure for establishing performance of all heat exchangers
EN 14705:2005 热交换器.湿冷却塔热性能的评价和测量方法
This European Standard specifies requirements, test methods and acceptance tests for thermal performances pumping head verification of wet cooling
Heat exchangers - Method of measurement and evaluation of thermal performances of wet cooling towers
NF E38-423*NF EN 14705:2005 热交换器.湿冷却塔热性能的测量和评价方法
Heat exchangers - Method of measurement and evaluation of thermal performances of wet cooling towers.
CSA Z9360-2-07-CAN/CSA-2007 麻醉和呼吸设备.使人体呼吸气体增湿的热和湿气交换器(ECH).第2部分:潮气量最小为250ml的气管造口病人用热
Canadian Standards Association (CSA) standards are developed through a consensus standards development process approved by the Standards Council
Mat閞iel d'anesth閟ie et de r閍nimation respiratoire ?蒫hangeurs de chaleur et d'humidit?(ECH) utilis閟 pour humidifier les gaz respir閟 par les 阾res humains ?Partie 2: ECH pour utilisation avec des patients trach閛tomis閟 ayant des volumes courants d'a
GOST R EN 14705-2011 热交换器. 湿式冷却塔热性能的测量和评估方法
Heat exchangers. Methods of measurement and evaluation of thermal performances of wet cooling towers
BS EN 14705:2005 热交换器.湿式冷却塔热性能的测量和评定方法
This European Standard specifies requirements, test methods and acceptance tests for thermal performances pumping head verification of wet cooling
Heat exchangers - Method of measurement and evaluation of thermal performances of wet cooling towers
KS P ISO 9360-2:2009 麻醉和呼吸设备.使人体呼吸气体增湿的热和潮气交换器(HMEs).第2部分:潮气量最小为250mL的气管造口病人用热和潮气交换器
이 표준은 KS P ISO 9360-1을 기반으로 호흡 시스템 필터와 연결된 것을 포함하여
Anaesthetic and respiratory equipment－Heat and moisture exchangers(HMEs) for humidifying respired gases in humans－Part 2：HMEs for use with tracheostomized patients having minimum tidal volumes of 250 mL
CSA Z9360-1-07-CAN/CSA-2007 麻醉和呼吸设备.人体增湿呼吸气体用热及水分交换器(ECH).第1部分:250ml最小呼吸气容积的热及水分交换器
Canadian Standards Association (CSA) standards are developed through a consensus standards development process approved by the Standards Council
Anaesthetic and respiratory equipment ?Heat and moisture exchangers (HMEs) for humidifying respired gases in humans ?Part 1: HMEs for use with minimum tidal volumes of 250 mL first edition
EN ISO 9360-2:2002 麻醉和呼吸设备.使人体呼吸湿润气体用热和潮气交换器(HMEs).第2部分:250ml最小量气管造口病人用热和潮气交换器 ISO 9360-2-2001
Anaesthetic and respiratory equipment - Heat and moisture exchangers (HMEs) for humidifying respired gases in humans - Part 2: HMEs for use with tracheostomized patients having minimum tidal volumes of 250 ml ISO 9360-2:2001
EN ISO 9360-2:2009 麻醉和呼吸设备.使人体呼吸气体增湿的热和潮气交换器(HMEs).第2部分:潮气量最小为250毫升的气管造口病人用
This part of ISO 9360 is based on ISO 9360-1:2000 and specifies certain requirements and test methods for heat and moisture exchangers (HMEs) without
Anaesthetic and respiratory equipment - Heat and moisture exchangers (HMEs) for humidifying respired gases in humans - Part 2: HMEs for use with tracheostomized patients having minimum tidal volumes of 250 ml (ISO 9360-2:2001)
GB/T 151-2014 热交换器
本标准规定了金属制热交换器的通用要求,并规定了管壳式热交换器材料、设计、制造、检验、验收及其安装、使用的要求。本标准的通用要求适用于管壳式热交换器及其他结构型式热交换器,本标准的所有内容适用于管壳式热交换器。本标准适用的设计压力:a) 管壳式热交换器的设计压力不大于35 MPa;b) 其他结构型式
Heat exchangers
ASHRAE EQUIP SI CH 47-2008 热交换器
HEAT EXCHANGERS
JB/T 4752-2009 板式热交换器
NF E38-321*NF EN 305:1997 热交换器 热交换器性能的定义和确定各种热交换器性能的试验程序
Heat exchangers. Definitions of performance of heat exchangers and the general test procedure for establishing performance of all heat exchangers.
DD ENV 305-1990 热交换器.热交换器性能定义和所有热交换器性能规定通用试验规程
Heat Exchangers - Definitions of Performance of Heat Exchangers and the General Test Procedure for Establishing Performance of All Heat Exchangers
NB/T 47004-2009 板式热交换器
本标准规定了板式热交换器的设计、制造、检验与验收要求。 本标准适用于垫式片、半焊式板式热交换器。其他形式的板式热交换器在参照本标准进行设计、制造与检验时，应得到需方的认可和同意。 本标准适用的设计温度范围应按垫式与其他元件材料允许的使用温度范围确定
Plate heat exchangers
编辑：北检院编辑部
