通用无线电设备检测

📅 发布时间:2024-05-27 👤 来源:北检院 👁 阅读:

HD 466.8 S1-1986 移动电台通信用线电设备的测量方法.第8部分:天线的测量方法

Methods of measurement for radio equipment used in the mobile services; part 8: methods of measurement for antennas

BS 6160-1:1989 移动通信用线电设备.第1部分:一般要求和测试条件

This standard applies to radio transmitting and receiving equipment and systems used in the mobile services. This standard is restricted to land

Radio equipment used in mobile services - General requirements and conditions of measurement

AS/NZS 4355-2006 工作在30 MHz以下平率的移动电话和民用频段线电通信服务用线电通信设备

This Standard was prepared to specify the essential requirements and minimum standards for radiocommunications equipment intended to operate

Radiocommunications equipment used in the handphone and citizen band radio services operating at frequencies not exceeding 30 MHz

BS 6160-4:1981 移动通信用线电设备.第4部分:使单边带发射机(A3A,A3H或A3J)

Applies to transmitters having a.f. bandwidths not exceeding 10 kHz and using single-sideband amplitude modulation with full, reduced or suppressed

Radio equipment used in mobile services - Transmitters employing single-sideband emissions (A3A, A3H or A3J)

prEN 60489-2-1992 移动电台通信用线电设备的测量方法.第2部分:采用A3E、F3E或G3E发射的发射机

Methods of measurement for radio equipment used in the mobile services; part 2: transmitters employing A3E, F3E or G3E emissions (IEC 489-2:1991)

AS/NZS 4365-2002 UHF民用波段线电服务用线通信设备

Specifies essential requirements and minimum standards for radiocommunications equipment intended to operate in the citizen band radio service

Radiocommunications equipment used in the UHF citizen band radio service

prEN 60489-4-1992 移动电台通信用线电设备的测量方法.第4部分:采用单边发射的(R3E或J3E)发射机

Methods of measurement for radio equipment used in the mobile services; part 4: transmitters employing single-sideband emissions (R3E, H3E or J3E) (IEC 489-4:1991)

BS 6160-5:1989 移动通信用线电设备.第5部分:单边带(R3E,H3E或J3E)接收机测试方法

Covers receivers having audio frequency band-widths generally not exceeding 10 kHz for the reception of voice and other types of signals, using

Radio equipment used in mobile services - Methods of measurement for receivers employing single-sideband techniques (R3E, H3E or J3E)

HD 466.5 S1-1989 移动电台通信用线电设备的测量方法.第5部分:使用单边带技术的接收机(R3E,H3E或J3E)

Methods of Measurement for Radio Equipment Used in the Mobile Services Part 5: Receivers Employing Single- Sideband Techniques (R3E, H3E or J3E)

GJB 4210.2-2001 军用线电通信设备通用检验验收规程 短波电台

GB/T 13705-1992 船用线电通信设备一般要求

本标准规定了船用线电通信设备(以下简称设备)主要技术指标、试验方法、检验规则、标志及包装运输贮存通用技术要求。 本标准适用于安装在船舶上的线电通信设备

General requirements for shipboard radio communication installations

GJB 4210.1-2001 军用线电通信设备通用检验验收规程 超短波电台

GB/T 13705-2019 船用线电通信设备一般要求

General requirements for shipboard radio communication installations

JIS C 6002:1962 线电通信设备用铭牌

Name plates for radio equipments

CB* 805-1988 船用线电通信设备附件通用技术条件

本标准规定了船用线电通信设备附件的基本要求、试验方法、检验规则和包装、运输、标志等。 本标准适用于船用线电通信设备的天线引入套管、天线互换器、天线耦合器、天线开关、天线接地插座、去耦装置、转接插座、射频连接器、键控转换箱、天线笼、高频瓷件等

HD 466.8 S1-1986 移动电台通信用线电设备的测量方法.第8部分:天线的测量方法

Methods of measurement for radio equipment used in the mobile services; part 8: methods of measurement for antennas

BS 6160-1:1989 移动通信用线电设备.第1部分:一般要求和测试条件

This standard applies to radio transmitting and receiving equipment and systems used in the mobile services. This standard is restricted to land

Radio equipment used in mobile services - General requirements and conditions of measurement

AS/NZS 4355-2006 工作在30 MHz以下平率的移动电话和民用频段线电通信服务用线电通信设备

This Standard was prepared to specify the essential requirements and minimum standards for radiocommunications equipment intended to operate

Radiocommunications equipment used in the handphone and citizen band radio services operating at frequencies not exceeding 30 MHz

BS 6160-4:1981 移动通信用线电设备.第4部分:使单边带发射机(A3A,A3H或A3J)

Applies to transmitters having a.f. bandwidths not exceeding 10 kHz and using single-sideband amplitude modulation with full, reduced or suppressed

Radio equipment used in mobile services - Transmitters employing single-sideband emissions (A3A, A3H or A3J)

prEN 60489-2-1992 移动电台通信用线电设备的测量方法.第2部分:采用A3E、F3E或G3E发射的发射机

Methods of measurement for radio equipment used in the mobile services; part 2: transmitters employing A3E, F3E or G3E emissions (IEC 489-2:1991)

AS/NZS 4365-2002 UHF民用波段线电服务用线通信设备

Specifies essential requirements and minimum standards for radiocommunications equipment intended to operate in the citizen band radio service

Radiocommunications equipment used in the UHF citizen band radio service

prEN 60489-4-1992 移动电台通信用线电设备的测量方法.第4部分:采用单边发射的(R3E或J3E)发射机

Methods of measurement for radio equipment used in the mobile services; part 4: transmitters employing single-sideband emissions (R3E, H3E or J3E) (IEC 489-4:1991)

BS 6160-5:1989 移动通信用线电设备.第5部分:单边带(R3E,H3E或J3E)接收机测试方法

Covers receivers having audio frequency band-widths generally not exceeding 10 kHz for the reception of voice and other types of signals, using

Radio equipment used in mobile services - Methods of measurement for receivers employing single-sideband techniques (R3E, H3E or J3E)

HD 466.5 S1-1989 移动电台通信用线电设备的测量方法.第5部分:使用单边带技术的接收机(R3E,H3E或J3E)

Methods of Measurement for Radio Equipment Used in the Mobile Services Part 5: Receivers Employing Single- Sideband Techniques (R3E, H3E or J3E)

GJB 4210.2-2001 军用线电通信设备通用检验验收规程 短波电台

GB/T 13705-1992 船用线电通信设备一般要求

本标准规定了船用线电通信设备(以下简称设备)主要技术指标、试验方法、检验规则、标志及包装运输贮存通用技术要求。 本标准适用于安装在船舶上的线电通信设备

General requirements for shipboard radio communication installations

GJB 4210.1-2001 军用线电通信设备通用检验验收规程 超短波电台

GB/T 13705-2019 船用线电通信设备一般要求

General requirements for shipboard radio communication installations

JIS C 6002:1962 线电通信设备用铭牌

Name plates for radio equipments

CB* 805-1988 船用线电通信设备附件通用技术条件

本标准规定了船用线电通信设备附件的基本要求、试验方法、检验规则和包装、运输、标志等。 本标准适用于船用线电通信设备的天线引入套管、天线互换器、天线耦合器、天线开关、天线接地插座、去耦装置、转接插座、射频连接器、键控转换箱、天线笼、高频瓷件等

编辑:北检院编辑部

我们的优势

选择北检院的六大理由

📚

CMA/CNAS 双认证

旗下实验室具备国家认证认可监督管理委员会CMA资质认定及中国合格评定国家认可委员会CNAS实验室认可,检测报告具有国际公信力。

🔬

1000+ 台套先进设备

配备扫描电镜、气质联用仪、电感耦合等离子体质谱仪等国际先进检测仪器,确保数据精准可靠。

🏢

15000+ 平米实验室

拥有规模化专业检测基地,涵盖材料、化工、食品、环境等多个专业实验室,满足多领域检测需求。

👥

资深技术团队

汇聚材料科学、化学分析、环境工程等领域专家,拥有10年+行业经验,提供专业可靠的检测分析服务。

⏱

快速响应机制

标准检测周期短至3个工作日,加急服务24小时出具报告,全程一对一工程师跟进,确保高效交付。

🌎

全国服务网络

总部位于北京,山东设立分部,服务覆盖全国,为20万+客户提供便捷的一站式检测解决方案。

荣誉资质

旗下实验室资质荣誉

CMA 检验检测机构资质认定

CMA 检验检测机构资质认定

国家认证认可监督管理委员会颁发,具备向社会出具具有证明作用数据的资质。

CNAS 实验室认可证书

CNAS 实验室认可证书

中国合格评定国家认可委员会认可,检测结果获国际互认,具有国际公信力。

ISO 质量管理体系认证

ISO 质量管理体系认证

通过ISO 质量管理体系认证,管理体系实现规范化、标准化。

绿色低碳诚信示范创建企业

绿色低碳诚信示范创建企业

荣获绿色低碳诚信示范创建企业称号,践行可持续发展理念,推动绿色低碳转型,助力"双碳"目标实现。

北京市创新型中小企业

北京市"创新型"中小企业

经北京市经济和信息化局认定的创新型中小企业,具备较强创新能力与较高专业化水平,是优质中小企业梯度培育体系的重要基础力量。

北京市专精特新中小企业

北京市"专精特新"中小企业

经北京市经济和信息化局认定的专精特新中小企业,具备专业化、精细化、特色化、新颖化发展特征,在细分领域具有较强竞争优势。

查看全部资质

仪器设备

国际先进检测仪器,确保检测数据精准可靠

查看全部设备

检测流程

标准化流程,高效交付

01

需求沟通

客户提交检测需求,技术顾问一对一沟通,明确检测项目与标准。

➔
02

样品寄送

客户按照规范要求寄送样品,实验室确认样品状态与数量。

➔
03

实验检测

专业工程师按照标准方法进行检测分析,全程质量控制。

➔
04

数据审核

检测数据经多级审核,确保结果准确、可靠、可追溯。

➔
05

报告出具

出具检测报告,支持电子版与纸质版,快递送达。

VR实验室720°全景 NEW · 全新上线 VR实验室上线啦! 720°全景实景观览 · 足不出户走进实验室 立即体验 检测咨询 · 立即在线沟通