固态照明检测

📅 发布时间:2024-05-27 👤 来源:北检院 👁 阅读:

ANSI/NEMA/ANSLG C78.377-2011 电灯产品的色度规范

Specifications for the Chromaticity of Solid State Lighting Products for Electric Lamps

IESNA LM-79-2008 制品的电气和光度测量

This approved method describes the procedures to be followed and precautions to be observed in performing reproducible measurements of total

Electrical and Photometric Measurements of Solid-State Lighting Products

CSA C22.2 NO 184-M1988-1988 控制.第2版.通用指令第1-4号

Solid-State Lighting Controls Second Edition; General Instruction No 1-4

Solid-State Lighting Controls Second Edition; General Instruction No 1-4

NEMA ANSLG C78.377-2008 美国电灯标准.产品的色度规范

American National Standard for electric lamps?Specifications for the Chromaticity of Solid State Lighting Products

CIE X034-2010 特别强调LEDs和的灯光和会议的研究论文选集

SELECTED PAPERS of the Light and Lighting Conference with Special Emphasis on LEDs and Solid State Lighting

ANSI/UL 8754-2013 (LED)发动机和阵列用支撑圈,基础,以及连接器安全性标准

Standard for Safety for Holders, Bases, and Connectors for Solid-State (LED) Light Engines and Arrays

ANSI C136.37-2011 道路和区域设备.道路和区域光源

This standard defines interchangeability of and some minimum requirements for solid state light (SSL) source fixtures, also referred to as luminaires

Roadway and Area Lighting Equipment - Solid State Light Sources Used in Roadway and Area Lighting

DLA MS27710 REV D-2003 28 V直流航空体状闪光信号装

This specification is approved for use by all Departments and Agencies of the Department of Defense

FLASHER, SOLID STATE, AIRCRAFT NAVIGATIONAL LIGHT, 28 VDC

DIN 5044-1:1981 定式交通.汽车交通的道路.

Stationary traffic lighting; street lighting for automobile traffic

Stationary traffic lighting; street lighting for automobile traffic

SAE J567-2010 电源位系统

This SAE Standard references the performance and functional requirements of the International Electrotechnical Commission (IEC) and its U.S. member

Lamp Source Retention System

T/CSA 044-2017 道路现场动测量方法

本标准适用于户外道路照明质量的现场动态测量

Road lighting scene dynamic measurement method

NEMA C136.37-2011 道路和区域设备.道路和区域光源

Roadway and Area Lighting Equipment- Solid State Light Sources Used in Roadway and Area Lighting

GM 9984267-1995 设备的花耐磨涂层

Stoff zum Überziehen von Sitzen und Rückenlehnen. Fabric for covering of seats and seat backs

Thermal Cured Abrasion Resistant Coatings for Lighting Applications Revision A

SAE J587-2003 牌设备(后牌设备)

This SAE Standard provides test procedures, requirements, and guidelines for vehicular license plate illumination devices

License Plate Illumination Devices (Rear Registration Plate Illumination Devices)

SAE J587-2012 牌设备(后牌设备)

This SAE Standard provides test procedures, requirements, and guidelines for vehicular license plate illumination devices

License Plate Illumination Devices (Rear Registration Plate Illumination Devices)

ANSI/NEMA/ANSLG C78.377-2011 电灯产品的色度规范

Specifications for the Chromaticity of Solid State Lighting Products for Electric Lamps

IESNA LM-79-2008 制品的电气和光度测量

This approved method describes the procedures to be followed and precautions to be observed in performing reproducible measurements of total

Electrical and Photometric Measurements of Solid-State Lighting Products

CSA C22.2 NO 184-M1988-1988 控制.第2版.通用指令第1-4号

Solid-State Lighting Controls Second Edition; General Instruction No 1-4

Solid-State Lighting Controls Second Edition; General Instruction No 1-4

NEMA ANSLG C78.377-2008 美国电灯标准.产品的色度规范

American National Standard for electric lamps?Specifications for the Chromaticity of Solid State Lighting Products

CIE X034-2010 特别强调LEDs和的灯光和会议的研究论文选集

SELECTED PAPERS of the Light and Lighting Conference with Special Emphasis on LEDs and Solid State Lighting

ANSI/UL 8754-2013 (LED)发动机和阵列用支撑圈,基础,以及连接器安全性标准

Standard for Safety for Holders, Bases, and Connectors for Solid-State (LED) Light Engines and Arrays

ANSI C136.37-2011 道路和区域设备.道路和区域光源

This standard defines interchangeability of and some minimum requirements for solid state light (SSL) source fixtures, also referred to as luminaires

Roadway and Area Lighting Equipment - Solid State Light Sources Used in Roadway and Area Lighting

DLA MS27710 REV D-2003 28 V直流航空体状闪光信号装

This specification is approved for use by all Departments and Agencies of the Department of Defense

FLASHER, SOLID STATE, AIRCRAFT NAVIGATIONAL LIGHT, 28 VDC

DIN 5044-1:1981 定式交通.汽车交通的道路.

Stationary traffic lighting; street lighting for automobile traffic

Stationary traffic lighting; street lighting for automobile traffic

SAE J567-2010 电源位系统

This SAE Standard references the performance and functional requirements of the International Electrotechnical Commission (IEC) and its U.S. member

Lamp Source Retention System

T/CSA 044-2017 道路现场动测量方法

本标准适用于户外道路照明质量的现场动态测量

Road lighting scene dynamic measurement method

NEMA C136.37-2011 道路和区域设备.道路和区域光源

Roadway and Area Lighting Equipment- Solid State Light Sources Used in Roadway and Area Lighting

GM 9984267-1995 设备的花耐磨涂层

Stoff zum Überziehen von Sitzen und Rückenlehnen. Fabric for covering of seats and seat backs

Thermal Cured Abrasion Resistant Coatings for Lighting Applications Revision A

SAE J587-2003 牌设备(后牌设备)

This SAE Standard provides test procedures, requirements, and guidelines for vehicular license plate illumination devices

License Plate Illumination Devices (Rear Registration Plate Illumination Devices)

SAE J587-2012 牌设备(后牌设备)

This SAE Standard provides test procedures, requirements, and guidelines for vehicular license plate illumination devices

License Plate Illumination Devices (Rear Registration Plate Illumination Devices)

编辑:北检院编辑部

我们的优势

选择北检院的六大理由

📚

CMA/CNAS 双认证

旗下实验室具备国家认证认可监督管理委员会CMA资质认定及中国合格评定国家认可委员会CNAS实验室认可,检测报告具有国际公信力。

🔬

1000+ 台套先进设备

配备扫描电镜、气质联用仪、电感耦合等离子体质谱仪等国际先进检测仪器,确保数据精准可靠。

🏢

15000+ 平米实验室

拥有规模化专业检测基地,涵盖材料、化工、食品、环境等多个专业实验室,满足多领域检测需求。

👥

资深技术团队

汇聚材料科学、化学分析、环境工程等领域专家,拥有10年+行业经验,提供专业可靠的检测分析服务。

快速响应机制

标准检测周期短至3个工作日,加急服务24小时出具报告,全程一对一工程师跟进,确保高效交付。

🌎

全国服务网络

总部位于北京,山东设立分部,服务覆盖全国,为20万+客户提供便捷的一站式检测解决方案。

荣誉资质

旗下实验室资质荣誉

CMA 检验检测机构资质认定

CMA 检验检测机构资质认定

国家认证认可监督管理委员会颁发,具备向社会出具具有证明作用数据的资质。

CNAS 实验室认可证书

CNAS 实验室认可证书

中国合格评定国家认可委员会认可,检测结果获国际互认,具有国际公信力。

ISO 质量管理体系认证

ISO 质量管理体系认证

通过ISO 质量管理体系认证,管理体系实现规范化、标准化。

绿色低碳诚信示范创建企业

绿色低碳诚信示范创建企业

荣获绿色低碳诚信示范创建企业称号,践行可持续发展理念,推动绿色低碳转型,助力"双碳"目标实现。

北京市创新型中小企业

北京市"创新型"中小企业

经北京市经济和信息化局认定的创新型中小企业,具备较强创新能力与较高专业化水平,是优质中小企业梯度培育体系的重要基础力量。

北京市专精特新中小企业

北京市"专精特新"中小企业

经北京市经济和信息化局认定的专精特新中小企业,具备专业化、精细化、特色化、新颖化发展特征,在细分领域具有较强竞争优势。

查看全部资质

仪器设备

国际先进检测仪器,确保检测数据精准可靠

查看全部设备

检测流程

标准化流程,高效交付

01

需求沟通

客户提交检测需求,技术顾问一对一沟通,明确检测项目与标准。

02

样品寄送

客户按照规范要求寄送样品,实验室确认样品状态与数量。

03

实验检测

专业工程师按照标准方法进行检测分析,全程质量控制。

04

数据审核

检测数据经多级审核,确保结果准确、可靠、可追溯。

05

报告出具

出具检测报告,支持电子版与纸质版,快递送达。

VR实验室720°全景 NEW · 全新上线 VR实验室上线啦! 720°全景实景观览 · 足不出户走进实验室 立即体验