SY/T 4107-2005 复合防腐涂层各层厚度破坏性测量方法
本标准规定了复合防腐涂层各层厚度破坏性测量的测量方法，该方法通过用显微镜观察在防腐涂层上切割的精确角形切割面来测量防腐涂层的各层厚度。 本标准适用于厚度小于1.3mm的复合防腐涂料，如复合防腐涂层的总厚度大于1.3mm，可以去除表面防腐涂层，达到测量范围要求，来测量内层防腐涂层
Standard test methods for measurement of dry film thickness of mult-coating system by destructive means
PN H04623-1986 腐蚀防护．损法金属涂层的厚度测量
Przedmiotem normy s? po-równawcze nieniszcz?ce metody pomiarów grubo?ci metalowych pow?ok elektrolitycznych, chemicznych i zanurzeniowych
Corrosion protection Thickness measurement of metallic coatings by the nondestructive methods
SN 640 560 b-1985 通过金属涂层防腐．电解工艺．层厚规定
GM 9986165-1998 框架防腐涂层
Freigabemuster, für die diese Vorschrift zutrifft, müssen nach dieser Vorschrift geprüft werden und von der Produktentwicklung und Konstruktion
Anti-Corrosion Coating for Frames
CSN 03 8156-1987 防腐蚀保护措施．金属及其他非有机涂层．破环性方法厚度测定
Schválení ST SEV 5290-85 doporu?ilo federální ministerstvo hutnictví a tě?-kého strojírenství. Zpracovatel a oborové normaliza?ní st?edisko: Státní v
Protection against corrosion. Metallic and other non-organic coatings. Measurement of thickness by destructive methods
PN H97055-1974 防腐蚀．热带涂料涂层
Przedmiotem normy s? pokrycia lakierowe stosowane do ochrony wyrobów metalowych, przeznaczonych do u?ytkowania w naturalnych warunkach klimatów
Corrosion protection Paint coatings for tropics
ARMY MIL-C-10799 H VALID NOTICE 1-1989 防火防霉乙烯基涂层涂棉布
MIL-C-10799H dated 29 March 1983 has been reviewed and determined to be valid for use in acquisition
CLOTH, COATED, COTTON, VINYL COATED, FIRE AND MILDEW RESISTANT
ARMY MIL-C-10799 H-1983 防火防霉乙烯基涂层涂棉布
Th'is document covers the requirements for waterproof, fire and mildew resistant, vinyl-coated cotton cloth(see 6.1
CLOTH, COATED, COTTON, VINYL COATED, FIRE AND MILDEW RESISTANT
HG/T 4077-2009 防腐蚀涂层涂装技术规范
本标准规定了防腐蚀涂层涂装的基材处理及要求、材料要求、涂装要求、质量检查与安全以及质量验收。 本标准适用于气态腐蚀环境下以钢结构为主的金属基材和以混凝土为主的非金属基材的防腐蚀涂层涂装
Anticorrosion coating technical specification
INTERN TMS 4520-2009 黑色防腐锌铝涂层
Black Corrosion-Resistant Zinc-Aluminum Coating
INTERN TMS 4510-2009 熔性防腐焊通涂层
Coating, Weld Through, Corrosion Resistant, Hot Melt
EN 15819:2011 防水用聚合物改性沥青厚涂层.充分干燥时涂层的厚度缩减.
This European Standard specifies a procedure for determining the reduction in the thickness of polymer modified bituminous thick coatings due
Polymer modified bituminous thick coatings for waterproofing - Reduction of the thickness of the layer when fully dried
SY/T 0066-1999 钢管防腐层厚度的损测量方法(磁性法)
本标准规定了一种测定钢质管道外表面非磁性防腐层干膜厚度损测量的试验方法。 本标准适用于测量钢管直径不小于13mm、厚度6mm以下的防腐层。本标准不适用于测量太柔软或受压时易变形的防腐层
Standard test method for nondesreuctive measurement of film thickness of pipeline coating on steel (magnetic method)
SFS 4959 E-1983 防腐涂层．施涂方法和油漆
In case of interpretation disputes the Finnish version applies. Dateoftranslation 1987-03-23.
BS EN 15819:2011 防水用聚合物改性沥青厚涂层.完全干燥后涂层厚度的减少量
This European Standard specifies a procedure for determining the reduction in the thickness of polymer modified bituminous thick coatings due
Polymer modified bituminous thick coatings for waterproofing. Reduction of the thickness of the layer when fully dried
SY/T 4107-2005 复合防腐涂层各层厚度破坏性测量方法
本标准规定了复合防腐涂层各层厚度破坏性测量的测量方法，该方法通过用显微镜观察在防腐涂层上切割的精确角形切割面来测量防腐涂层的各层厚度。 本标准适用于厚度小于1.3mm的复合防腐涂料，如复合防腐涂层的总厚度大于1.3mm，可以去除表面防腐涂层，达到测量范围要求，来测量内层防腐涂层
Standard test methods for measurement of dry film thickness of mult-coating system by destructive means
PN H04623-1986 腐蚀防护．损法金属涂层的厚度测量
Przedmiotem normy s? po-równawcze nieniszcz?ce metody pomiarów grubo?ci metalowych pow?ok elektrolitycznych, chemicznych i zanurzeniowych
Corrosion protection Thickness measurement of metallic coatings by the nondestructive methods
SN 640 560 b-1985 通过金属涂层防腐．电解工艺．层厚规定
GM 9986165-1998 框架防腐涂层
Freigabemuster, für die diese Vorschrift zutrifft, müssen nach dieser Vorschrift geprüft werden und von der Produktentwicklung und Konstruktion
Anti-Corrosion Coating for Frames
CSN 03 8156-1987 防腐蚀保护措施．金属及其他非有机涂层．破环性方法厚度测定
Schválení ST SEV 5290-85 doporu?ilo federální ministerstvo hutnictví a tě?-kého strojírenství. Zpracovatel a oborové normaliza?ní st?edisko: Státní v
Protection against corrosion. Metallic and other non-organic coatings. Measurement of thickness by destructive methods
PN H97055-1974 防腐蚀．热带涂料涂层
Przedmiotem normy s? pokrycia lakierowe stosowane do ochrony wyrobów metalowych, przeznaczonych do u?ytkowania w naturalnych warunkach klimatów
Corrosion protection Paint coatings for tropics
ARMY MIL-C-10799 H VALID NOTICE 1-1989 防火防霉乙烯基涂层涂棉布
MIL-C-10799H dated 29 March 1983 has been reviewed and determined to be valid for use in acquisition
CLOTH, COATED, COTTON, VINYL COATED, FIRE AND MILDEW RESISTANT
ARMY MIL-C-10799 H-1983 防火防霉乙烯基涂层涂棉布
Th'is document covers the requirements for waterproof, fire and mildew resistant, vinyl-coated cotton cloth(see 6.1
CLOTH, COATED, COTTON, VINYL COATED, FIRE AND MILDEW RESISTANT
HG/T 4077-2009 防腐蚀涂层涂装技术规范
本标准规定了防腐蚀涂层涂装的基材处理及要求、材料要求、涂装要求、质量检查与安全以及质量验收。 本标准适用于气态腐蚀环境下以钢结构为主的金属基材和以混凝土为主的非金属基材的防腐蚀涂层涂装
Anticorrosion coating technical specification
INTERN TMS 4520-2009 黑色防腐锌铝涂层
Black Corrosion-Resistant Zinc-Aluminum Coating
INTERN TMS 4510-2009 熔性防腐焊通涂层
Coating, Weld Through, Corrosion Resistant, Hot Melt
EN 15819:2011 防水用聚合物改性沥青厚涂层.充分干燥时涂层的厚度缩减.
This European Standard specifies a procedure for determining the reduction in the thickness of polymer modified bituminous thick coatings due
Polymer modified bituminous thick coatings for waterproofing - Reduction of the thickness of the layer when fully dried
SY/T 0066-1999 钢管防腐层厚度的损测量方法(磁性法)
本标准规定了一种测定钢质管道外表面非磁性防腐层干膜厚度损测量的试验方法。 本标准适用于测量钢管直径不小于13mm、厚度6mm以下的防腐层。本标准不适用于测量太柔软或受压时易变形的防腐层
Standard test method for nondesreuctive measurement of film thickness of pipeline coating on steel (magnetic method)
SFS 4959 E-1983 防腐涂层．施涂方法和油漆
In case of interpretation disputes the Finnish version applies. Dateoftranslation 1987-03-23.
BS EN 15819:2011 防水用聚合物改性沥青厚涂层.完全干燥后涂层厚度的减少量
This European Standard specifies a procedure for determining the reduction in the thickness of polymer modified bituminous thick coatings due
Polymer modified bituminous thick coatings for waterproofing. Reduction of the thickness of the layer when fully dried
编辑：北检院编辑部
