ANSI Z21.80a-2012 管路压力调节器(同CSA 6.22a)
This standard applies to line pressure regulators, either individual or in combination with over pressure protection devices, hereinafter referred
Standard for Line Pressure Regulators (same as CSA 6.22a)
CSA 6.22-2003-2003 管路压力调节器.第2版.CSA/ANSI Z21.80-2003.更正 A:2005
Line Pressure Regulators Second Edition; CSA/ANSI Z21.80-2003; Addenda A:2005
Line Pressure Regulators Second Edition
ISO 6953-1:1990 气压传动.空气管路压力调节器.第1部分:商业文献中包含的主要特性和特殊要求
Pneumatic fluid power — Air line pressure regulators — Part 1: Main characteristics to be included in commercial literature and specific requirements
QB/T 2533-2001 空调器用管路件
本标准规定了制冷剂为R22的房间空气调节器用管路件(包括异型三通或多通、过滤器、储液器、消音器等)的产品分类、技术要求、试验方法、检验规则、标志、包装、运输、贮存。 本标准适用于GB/T 7725-1996《房间空气调节器》中规定的各种型式空气调节器上使用的各种型式管路件
Pipework components of air-conditioners
BS EN ISO 10524-2:2007 医用气体的压力调节器.歧管和线管压力调节器
ISO 10524-2:2005 specifies requirements for manifold pressure regulators intended to be connected to cylinders with nominal filling pressures up to 25
Pressure regulators for use with medical gases - Manifold and line pressure regulators
BS EN 738-2:1999 医用气体用的压力调节器.供气支管压力调节器和输气管道压力调节器
1 This European Standard applies to manifold pressure regulators and line pressure regulators intended for the supply of pipeline systems
Pressure regulators for use with medical gases - Manifold and line pressure regulators
DLA MIL-M-38510/102 C VALID NOTICE 1-2008 单片线性调压器微电路
Microcircuits, Linear, Voltage Regulator, Monolithic Silicon
YY/T 1439.2-2016 医用气体压力调节器第2部分:汇流排压力调节器和管道压力调节器
*YY/T 1439的本部分规定了预期与15 ℃时最大标称灌充压力为25 000 kPa的气瓶相连接的汇流排压力调节器(在3.6中定义)和最大进气口压力为3 000 kPa、在管道系统中使用的管道压力调节器(在3.4中定义)的要求，压力调节器预期用于下列医用气体： --氧气； --氧化亚氮(笑气
Pressure regulators for use with medical gases.Part 2:Manifold and line pressure regulators
DLA SMD-5962-07229 REV A-2008 单片硅正电压调节器可调节高压线性微电路
MICROCIRCUIT, LINEAR, HIGH VOLTAGE, ADJUSTABLE, POSITIVE VOLTAGE REGULATOR, MONOLITHIC SILICON
T/ZZB 2547-2021 汽车空调外置管路消音器
本文件规定了汽车空调外置管路消音器的术语和定义、 分类、基本要求、技术要求、试验方法、检验规则、标志、包装、运输、贮存和质量承诺。 本文件适用于汽车空调制冷高压软管和低压软管用的外置管路消音器
Muffler for automobile air conditioning external piping
TCVN 7741-2-2007 医用气体用的压力调节器.第2部分:歧管和线管压力调节器
Pressure regulators for use with medical gases.Part 2: Manifold and line pressure regulators
DS/EN ISO 10524-2:2006 用于医用气体的压力调节器 第2部分：歧管和管线压力调节器
This standard specifies requirements for manifold pressure regulators intended to be connected to cylinders with nominal filling pressures up to 25
Pressure regulators for use with medical gases - Part 2: Manifold and line pressure regulators
DLA SMD-5962-09207 REV B-2012 微电路，混合，稳压器低压差，正负，可调
MICROCIRCUIT, HYBRID, VOLTAGE REGULATOR LOW DROPOUT, POSITIVE AND NEGATIVE, ADJUSTABLE
DLA SMD-5962-09207 REV D-2012 微电路，混合，稳压器低压差，正负，可调
MICROCIRCUIT, HYBRID, VOLTAGE REGULATOR LOW DROPOUT, POSITIVE AND NEGATIVE, ADJUSTABLE
DLA SMD-5962-11205 REV A-2013 微电路，混合，稳压器超低压差，正，可调，
MICROCIRCUIT, HYBRID, VOLTAGE REGULATOR ULTRA LOW DROPOUT, POSITIVE, ADJUSTABLE,
ANSI Z21.80a-2012 管路压力调节器(同CSA 6.22a)
This standard applies to line pressure regulators, either individual or in combination with over pressure protection devices, hereinafter referred
Standard for Line Pressure Regulators (same as CSA 6.22a)
CSA 6.22-2003-2003 管路压力调节器.第2版.CSA/ANSI Z21.80-2003.更正 A:2005
Line Pressure Regulators Second Edition; CSA/ANSI Z21.80-2003; Addenda A:2005
Line Pressure Regulators Second Edition
ISO 6953-1:1990 气压传动.空气管路压力调节器.第1部分:商业文献中包含的主要特性和特殊要求
Pneumatic fluid power — Air line pressure regulators — Part 1: Main characteristics to be included in commercial literature and specific requirements
QB/T 2533-2001 空调器用管路件
本标准规定了制冷剂为R22的房间空气调节器用管路件(包括异型三通或多通、过滤器、储液器、消音器等)的产品分类、技术要求、试验方法、检验规则、标志、包装、运输、贮存。 本标准适用于GB/T 7725-1996《房间空气调节器》中规定的各种型式空气调节器上使用的各种型式管路件
Pipework components of air-conditioners
BS EN ISO 10524-2:2007 医用气体的压力调节器.歧管和线管压力调节器
ISO 10524-2:2005 specifies requirements for manifold pressure regulators intended to be connected to cylinders with nominal filling pressures up to 25
Pressure regulators for use with medical gases - Manifold and line pressure regulators
BS EN 738-2:1999 医用气体用的压力调节器.供气支管压力调节器和输气管道压力调节器
1 This European Standard applies to manifold pressure regulators and line pressure regulators intended for the supply of pipeline systems
Pressure regulators for use with medical gases - Manifold and line pressure regulators
DLA MIL-M-38510/102 C VALID NOTICE 1-2008 单片线性调压器微电路
Microcircuits, Linear, Voltage Regulator, Monolithic Silicon
YY/T 1439.2-2016 医用气体压力调节器第2部分:汇流排压力调节器和管道压力调节器
*YY/T 1439的本部分规定了预期与15 ℃时最大标称灌充压力为25 000 kPa的气瓶相连接的汇流排压力调节器(在3.6中定义)和最大进气口压力为3 000 kPa、在管道系统中使用的管道压力调节器(在3.4中定义)的要求，压力调节器预期用于下列医用气体： --氧气； --氧化亚氮(笑气
Pressure regulators for use with medical gases.Part 2:Manifold and line pressure regulators
DLA SMD-5962-07229 REV A-2008 单片硅正电压调节器可调节高压线性微电路
MICROCIRCUIT, LINEAR, HIGH VOLTAGE, ADJUSTABLE, POSITIVE VOLTAGE REGULATOR, MONOLITHIC SILICON
T/ZZB 2547-2021 汽车空调外置管路消音器
本文件规定了汽车空调外置管路消音器的术语和定义、 分类、基本要求、技术要求、试验方法、检验规则、标志、包装、运输、贮存和质量承诺。 本文件适用于汽车空调制冷高压软管和低压软管用的外置管路消音器
Muffler for automobile air conditioning external piping
TCVN 7741-2-2007 医用气体用的压力调节器.第2部分:歧管和线管压力调节器
Pressure regulators for use with medical gases.Part 2: Manifold and line pressure regulators
DS/EN ISO 10524-2:2006 用于医用气体的压力调节器 第2部分：歧管和管线压力调节器
This standard specifies requirements for manifold pressure regulators intended to be connected to cylinders with nominal filling pressures up to 25
Pressure regulators for use with medical gases - Part 2: Manifold and line pressure regulators
DLA SMD-5962-09207 REV B-2012 微电路，混合，稳压器低压差，正负，可调
MICROCIRCUIT, HYBRID, VOLTAGE REGULATOR LOW DROPOUT, POSITIVE AND NEGATIVE, ADJUSTABLE
DLA SMD-5962-09207 REV D-2012 微电路，混合，稳压器低压差，正负，可调
MICROCIRCUIT, HYBRID, VOLTAGE REGULATOR LOW DROPOUT, POSITIVE AND NEGATIVE, ADJUSTABLE
DLA SMD-5962-11205 REV A-2013 微电路，混合，稳压器超低压差，正，可调，
MICROCIRCUIT, HYBRID, VOLTAGE REGULATOR ULTRA LOW DROPOUT, POSITIVE, ADJUSTABLE,
编辑：北检院编辑部
