IEEE Std C37.90-1989 与电源设备有关的继电器和中继系统
Included in Protective Relaying Systems Standards Collection
Relays and relay systems associated with electric power apparatus
IEEE Std C37.90-2005 与电源设备有关的继电器和中继系统
This standard applies only to relays and relay systems used to protect and control power apparatus
Relays and relay systems associated with electric power apparatus
ANSI/IEEE C37.90:2011 与电源设备配套的继电器和继电器系统
Specifies standard service conditions, standard ratings, performance requirements, and testing requirements for relays and relay systems used
Relays and Relay Systems Associated with Electric Power Apparatus
GOST R 58585-2019 采矿设备 电源和控制系统的一般安全要求
Mining equipment. General safety requirements for power supply and control systems
GB/T 18122-2000 视听设备和系统 标牌-电源标志
本标准适用于音频、视频、电视和视听工程领域的电子设备及系统，特别是对使用人员需进行技术培训的设备。本标准仅适用于使用不超过单相250V交流电压或不超过50V的直流电压、通过插头和插座连接电源的设备。 某些设备可能适用于多种电源电压和频率。其中一些设备用户必须作些调整以适应特定的
Audio visual equipment and systems Rating plates-Marking of electricity supply
TCVN 6766-2000 视听设备和系统.标牌.电源标志
Audiovisual equipment and systems.Rating plates.Marking of electricity supply
IEC 61062:1991 视听设备和系统.定额牌.电源的符号
Audiovisual equipment and systems; rating plates; marking of electricity supply
IEC 22/145/DTS:2009 IEC/TS 62578:电力电子系统和设备.有源动力整流器设备的操作和特性
IEC/TS 62578: Power electronics systems and equipment - Operations and characteristics of active infeed converter applications
DS/IEC/TS 62578:2010 电力电子系统和设备 有源馈电转换器应用的运行条件和特性
This part of IEC 62578 TS describes the operation conditions and typical characteristics of Active Infeed Converters of all technologies
Power electronics systems and equipment - Operation conditions and characteristics of active infeed converter applications
GB 39275-2020 电力电子系统和设备 有源馈电变流器（AIC）应用的运行条件和特性
本标准阐述了采用各种技术和拓扑的有源馈电变流器(AIC)的运行条件和典型特性,它们能连接在供电网络(电网)交流侧与电流或电压恒定的直流侧之间,且在正向和反向(回馈)两个方向进行电功 率(有功和功)变换。 通常,有源馈电变流需与所有电压和功率等级的调速电气传动系统(PDS)、不间断电源系统(CUPS
GB/T 39275-2020 电力电子系统和设备 有源馈电变流器（AIC）应用的运行条件和特性
本标准阐述了采用各种技术和拓扑的有源馈电变流器(AIC)的运行条件和典型特性,它们能连接在供电网络(电网)交流侧与电流或电压恒定的直流侧之间,且在正向和反向(回馈)两个方向进行电功率(有功和功)变换。通常,有源馈电变流器与所有电压和功率等级的调速电气传动系统(PDS)、不间断电源系统(UPS
Power electronics systems and equipment—Operation conditions and characteristics of active infeed converter (AIC) applications
LST EN 50065-2-3-2003 频率范围为 3 kHz 至 148.5 kHz 的低压电气装置信号 第 2-3 部分：在 3 kHz 至 95 kHz 频率范围内运行并供电力使用的电源通信设备和系统的抗扰度要求
Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz. Part 2-3: Immunity requirements for mains communications equipment and systems operating in the range of frequencies 3 kHz to 95 kHz and intended for use by elec
LST EN 50065-2-3-2003/AC-2010 频率范围为 3 kHz 至 148.5 kHz 的低压电气装置信号 第 2-3 部分：在 3 kHz 至 95 kHz 频率范围内运行并供电力使用的电源通信设备和系统的抗扰度要求
Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz. Part 2-3: Immunity requirements for mains communications equipment and systems operating in the range of frequencies 3 kHz to 95 kHz and intended for use by elec
DS/EN 50065-2-3/A1:2006 kHz 至 148.5 kHz 频率范围内低压电气装置的信号 第 2-3 部分：在 3 kHz 至 95 kHz 频率范围内运行并供 ele 使用的电源通信设备和系统的抗扰度要求
This standard applies to electrical equipment using signals in the frequency range 3 kHz to 95 kHz to transmit or receive information on low voltage
Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz - Part 2-3: Immunity requirements for mains communications equipment and systems operating in the range of frequencies 3 kHz to 95 kHz and intended for use by ele
DS/EN 50065-2-3/Corr:2004 kHz 至 148.5 kHz 频率范围内低压电气装置的信号 第 2-3 部分：在 3 kHz 至 95 kHz 频率范围内运行并供 ele 使用的电源通信设备和系统的抗扰度要求
This standard applies to electrical equipment using signals in the frequency range 3 kHz to 95 kHz to transmit or receive information on low voltage
Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz - Part 2-3: Immunity requirements for mains communications equipment and systems operating in the range of frequencies 3 kHz to 95 kHz and intended for use by ele
IEEE Std C37.90-1989 与电源设备有关的继电器和中继系统
Included in Protective Relaying Systems Standards Collection
Relays and relay systems associated with electric power apparatus
IEEE Std C37.90-2005 与电源设备有关的继电器和中继系统
This standard applies only to relays and relay systems used to protect and control power apparatus
Relays and relay systems associated with electric power apparatus
ANSI/IEEE C37.90:2011 与电源设备配套的继电器和继电器系统
Specifies standard service conditions, standard ratings, performance requirements, and testing requirements for relays and relay systems used
Relays and Relay Systems Associated with Electric Power Apparatus
GOST R 58585-2019 采矿设备 电源和控制系统的一般安全要求
Mining equipment. General safety requirements for power supply and control systems
GB/T 18122-2000 视听设备和系统 标牌-电源标志
本标准适用于音频、视频、电视和视听工程领域的电子设备及系统，特别是对使用人员需进行技术培训的设备。本标准仅适用于使用不超过单相250V交流电压或不超过50V的直流电压、通过插头和插座连接电源的设备。 某些设备可能适用于多种电源电压和频率。其中一些设备用户必须作些调整以适应特定的
Audio visual equipment and systems Rating plates-Marking of electricity supply
TCVN 6766-2000 视听设备和系统.标牌.电源标志
Audiovisual equipment and systems.Rating plates.Marking of electricity supply
IEC 61062:1991 视听设备和系统.定额牌.电源的符号
Audiovisual equipment and systems; rating plates; marking of electricity supply
IEC 22/145/DTS:2009 IEC/TS 62578:电力电子系统和设备.有源动力整流器设备的操作和特性
IEC/TS 62578: Power electronics systems and equipment - Operations and characteristics of active infeed converter applications
DS/IEC/TS 62578:2010 电力电子系统和设备 有源馈电转换器应用的运行条件和特性
This part of IEC 62578 TS describes the operation conditions and typical characteristics of Active Infeed Converters of all technologies
Power electronics systems and equipment - Operation conditions and characteristics of active infeed converter applications
GB 39275-2020 电力电子系统和设备 有源馈电变流器（AIC）应用的运行条件和特性
本标准阐述了采用各种技术和拓扑的有源馈电变流器(AIC)的运行条件和典型特性,它们能连接在供电网络(电网)交流侧与电流或电压恒定的直流侧之间,且在正向和反向(回馈)两个方向进行电功 率(有功和功)变换。 通常,有源馈电变流需与所有电压和功率等级的调速电气传动系统(PDS)、不间断电源系统(CUPS
GB/T 39275-2020 电力电子系统和设备 有源馈电变流器（AIC）应用的运行条件和特性
本标准阐述了采用各种技术和拓扑的有源馈电变流器(AIC)的运行条件和典型特性,它们能连接在供电网络(电网)交流侧与电流或电压恒定的直流侧之间,且在正向和反向(回馈)两个方向进行电功率(有功和功)变换。通常,有源馈电变流器与所有电压和功率等级的调速电气传动系统(PDS)、不间断电源系统(UPS
Power electronics systems and equipment—Operation conditions and characteristics of active infeed converter (AIC) applications
LST EN 50065-2-3-2003 频率范围为 3 kHz 至 148.5 kHz 的低压电气装置信号 第 2-3 部分：在 3 kHz 至 95 kHz 频率范围内运行并供电力使用的电源通信设备和系统的抗扰度要求
Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz. Part 2-3: Immunity requirements for mains communications equipment and systems operating in the range of frequencies 3 kHz to 95 kHz and intended for use by elec
LST EN 50065-2-3-2003/AC-2010 频率范围为 3 kHz 至 148.5 kHz 的低压电气装置信号 第 2-3 部分：在 3 kHz 至 95 kHz 频率范围内运行并供电力使用的电源通信设备和系统的抗扰度要求
Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz. Part 2-3: Immunity requirements for mains communications equipment and systems operating in the range of frequencies 3 kHz to 95 kHz and intended for use by elec
DS/EN 50065-2-3/A1:2006 kHz 至 148.5 kHz 频率范围内低压电气装置的信号 第 2-3 部分：在 3 kHz 至 95 kHz 频率范围内运行并供 ele 使用的电源通信设备和系统的抗扰度要求
This standard applies to electrical equipment using signals in the frequency range 3 kHz to 95 kHz to transmit or receive information on low voltage
Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz - Part 2-3: Immunity requirements for mains communications equipment and systems operating in the range of frequencies 3 kHz to 95 kHz and intended for use by ele
DS/EN 50065-2-3/Corr:2004 kHz 至 148.5 kHz 频率范围内低压电气装置的信号 第 2-3 部分：在 3 kHz 至 95 kHz 频率范围内运行并供 ele 使用的电源通信设备和系统的抗扰度要求
This standard applies to electrical equipment using signals in the frequency range 3 kHz to 95 kHz to transmit or receive information on low voltage
Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz - Part 2-3: Immunity requirements for mains communications equipment and systems operating in the range of frequencies 3 kHz to 95 kHz and intended for use by ele
编辑：北检院编辑部
