故障指示器（1）检测

DB53/T 813.1-2017 配电线路故障指示器及定位系统技术规范 第1部分：主站

Technical specifications for distribution line fault indicators and positioning systems Part 1: Master station

DLA MIL-PRF-83287 G (1)-2010 指示器、故障定位、一般规格

INDICATORS, FAULT LOCATING, GENERAL SPECIFICATION FOR

IEEE 495-1986 故障电路指示器试验指南

Guide for testing faulted circuit indicators

IEEE 495-1985 故障电路指示器测试指南

Guide for Testing Faulted Circuit Indicators

SJ 20955-2006 故障探测指示器通用规范

本规范规定了显示电气和电子设备工作状态的故障探测指示器（以下简称指示器）通用要求。 本规范适用于以遮光器、球状物、旋转盘指示，且是机械或电气复位式的故障探测指示器

Indicators, fault locating, general specification for

DL/T 1157-2012 配电线路故障指示器技术条件

本标准规定了配电系统中用于电力线路的短路和接地故障指示器的术语和定义、技术要求、试验方法、检验规则以及标志、包装和贮运的要求。本标准适用于电力系统35kV及以下电压等级配电系统配电线路的短路和接地故障指示器(以下简称指示器)的生产、检验、包装、运输及运行中检测

Specification of fault indicators for distribution lines

IEEE 495-2007 故障电路指示器的测试指南

This test code establishes definitions, service conditions, test procedures and test conditions for Faulted Circuit Indicators (FCI) for use on power

Guide for Testing Faulted Circuit Indicators

ANSI/IEEE Std 495-1986 IEEE 故障电路指示器测试指南

Definitions, service conditions, test procedures, and conditions for faulted circuit indicators for use on power distribution systems are established.

IEEE Guide for Testing Faulted Circuit Indicators

ANSI/IEEE 495:2007 故障电路指示器的试验指南

This test code establishes definitions, service conditions, test procedures and test conditions for Faulted Circuit Indicators (FCI) for use on power

Guide for Testing Faulted Circuit Indicators

DLA QPL-83287-24-2004 故障定位指示器一般规格

This list has been prepared for use by or for the Government in the acquisition of products covered by Specification MIL-PRF-83287. Listing

INDICATORS, FAULT LOCATING, GENERAL SPECIFICATION FOR

IEEE Std 495-2007 IEEE 故障电路指示器测试指南 Redline

Revision of IEEE Std 495-1986. Definitions, service conditions, test procedures, and test conditions for faulted circuit indicators for use on power

IEEE Guide for Testing Faulted Circuit Indicators - Redline

DLA MIL-PRF-83287 G-2007 故障定位指示器的一般规定

This specification covers fault locating indicators which display the operational status of electrical and electronic equipment

INDICATORS, FAULT LOCATING, GENERAL SPECIFICATION FOR

JIS E 3702:1974 道口信号机用故障报警指示器

Out of order indicators for level crossing signal

DB35/T 1801-2018 配电线路故障指示器通用技术条件

本标准规定了配电线路故障指示器的分类、使用条件、技术要求、试验方法、检验规则以及标志、包装、随机文件及储运条件等。 本标准适用于额定电压10 kV～35 kV、额定频率50 Hz的三相交流配电线路中定位线路故障、监测运行状态的故障指示器

General specification for distribution line fault indicator

IEEE Std 1610-2016 配电电路故障电路指示器应用 IEEE 指南

Information on what a faulted circuit indicator (FCI) is designed to do, along with methods for selecting and applying FCIs for 200 / 600

IEEE Guide for the Application of Faulted Circuit Indicators on Distribution Circuits

DB53/T 813.1-2017 配电线路故障指示器及定位系统技术规范 第1部分：主站

Technical specifications for distribution line fault indicators and positioning systems Part 1: Master station

DLA MIL-PRF-83287 G (1)-2010 指示器、故障定位、一般规格

INDICATORS, FAULT LOCATING, GENERAL SPECIFICATION FOR

IEEE 495-1986 故障电路指示器试验指南

Guide for testing faulted circuit indicators

IEEE 495-1985 故障电路指示器测试指南

Guide for Testing Faulted Circuit Indicators

SJ 20955-2006 故障探测指示器通用规范

本规范规定了显示电气和电子设备工作状态的故障探测指示器（以下简称指示器）通用要求。 本规范适用于以遮光器、球状物、旋转盘指示，且是机械或电气复位式的故障探测指示器

Indicators, fault locating, general specification for

DL/T 1157-2012 配电线路故障指示器技术条件

本标准规定了配电系统中用于电力线路的短路和接地故障指示器的术语和定义、技术要求、试验方法、检验规则以及标志、包装和贮运的要求。本标准适用于电力系统35kV及以下电压等级配电系统配电线路的短路和接地故障指示器(以下简称指示器)的生产、检验、包装、运输及运行中检测

Specification of fault indicators for distribution lines

IEEE 495-2007 故障电路指示器的测试指南

This test code establishes definitions, service conditions, test procedures and test conditions for Faulted Circuit Indicators (FCI) for use on power

Guide for Testing Faulted Circuit Indicators

ANSI/IEEE Std 495-1986 IEEE 故障电路指示器测试指南

Definitions, service conditions, test procedures, and conditions for faulted circuit indicators for use on power distribution systems are established.

IEEE Guide for Testing Faulted Circuit Indicators

ANSI/IEEE 495:2007 故障电路指示器的试验指南

This test code establishes definitions, service conditions, test procedures and test conditions for Faulted Circuit Indicators (FCI) for use on power

Guide for Testing Faulted Circuit Indicators

DLA QPL-83287-24-2004 故障定位指示器一般规格

This list has been prepared for use by or for the Government in the acquisition of products covered by Specification MIL-PRF-83287. Listing

INDICATORS, FAULT LOCATING, GENERAL SPECIFICATION FOR

IEEE Std 495-2007 IEEE 故障电路指示器测试指南 Redline

Revision of IEEE Std 495-1986. Definitions, service conditions, test procedures, and test conditions for faulted circuit indicators for use on power

IEEE Guide for Testing Faulted Circuit Indicators - Redline

DLA MIL-PRF-83287 G-2007 故障定位指示器的一般规定

This specification covers fault locating indicators which display the operational status of electrical and electronic equipment

INDICATORS, FAULT LOCATING, GENERAL SPECIFICATION FOR

JIS E 3702:1974 道口信号机用故障报警指示器

Out of order indicators for level crossing signal

DB35/T 1801-2018 配电线路故障指示器通用技术条件

本标准规定了配电线路故障指示器的分类、使用条件、技术要求、试验方法、检验规则以及标志、包装、随机文件及储运条件等。 本标准适用于额定电压10 kV～35 kV、额定频率50 Hz的三相交流配电线路中定位线路故障、监测运行状态的故障指示器

General specification for distribution line fault indicator

IEEE Std 1610-2016 配电电路故障电路指示器应用 IEEE 指南

Information on what a faulted circuit indicator (FCI) is designed to do, along with methods for selecting and applying FCIs for 200 / 600

IEEE Guide for the Application of Faulted Circuit Indicators on Distribution Circuits