变压器出线端子用绝缘防护罩检测

📅 发布时间:2024-05-27 👤 来源:北检院 👁 阅读:

DL/T 378-2010 线技术条件

本标准规定了变压器出线端子用绝缘防护罩的定义、命名、使用条件、试验方法、检验规则、包装、运输和储存。 本标准适用于工频6kV-10kV电力系统中变压器出线端子用的绝缘防护罩

General technical specification of dielectric shield for transformer terminals

DIN 42404:1985 小型标记.安全.可调和小型扼流

This standard applies to terminal markings for small transformers, safety isolating transformers, variable transformers and small chokes. It specifies

Terminal markings for small transformers, safety isolating transformers, variable transformers and small chokes

NF C66-107:1975 架空线和配件 电低于 1000 V 瓷料线(ac)

Insulators and fittings for overhead lines. Insulators of ceramic material for voltages lower than 1000 volts. Terminal insulators (ac).

MNOSZ 4821-1951 高,导言,表面设备-推导及电缆末

NF C66-207:1975 架空线和配件 电低于 1000 V 的玻璃线(AV)

Insulators and fittings for overhead lines. Glass insulators for voltages lower than 1000 V. Terminal insulators (AV).

SIS SEN 14-1951 E-1952 油的维

These recommendations concern rules for judging the con-dition of insulating oil contained in transformers and are in-tended as a supplement to SEN

JIS C 9742:2000 和安全.要求

この規格は,定格供給電圧が交流1000V以下及び500Hz以下の定格周波数をもつ,提携されるかそれとは別の据置形又は可搬形,単相又は多相,空冷形の絶縁変圧器及び安全絶縁変圧器で,次の値の定格出力を超えないものに適用する

Isolating transformers and safety isolating transformers -- Requirements

CNS 6073-1983 杆上引下线

本标准适用于额定电压 6600 V 以下之高压架空电线至杆上变压器一次侧,以交连聚乙烯、乙丙烯(EP)橡胶绝缘之单心引下用高压绝缘电线。注:本标准中{}所附加之数值及单位,系国际单位(SI)制做参考用

High - Voltage Drop Wire for Pole Tramsformer

DIN 46266-1:1988 高线.第1部分:陶瓷

The existing standard issued in 1948 has been brought into line with the present state of the art. The feed-through terminals for bolt connection

High-voltage feed-through terminals; ceramic insulator

T/CEC 407-2020 电力中低线化改造技术规范

本文件规定了电力变压器中低压侧出线绝缘化改造的范围、材料、施工、验收等技术要求。 本文件适用于电力变压器中低压侧的6 kV~35 kV 出线绝缘化改造

Technical specification for insulation transformation of medium and low voltage side outlets of power transformers

DIN 46225:1976 电缆套的冲

Stamped terminals with embrace of the insulation for insulated cables

Stamped terminals with embrace of the insulation for insulated cables

CSN 34 8105-1963

Caps for string insulators

CSA E742-94-CAN/CSA-1994 与安全.通指令第1号

This Standard outlines the requirements that apply, unless otherwise specified in a purchase order or individual standard, to structural quality

Isolating Transformers and Safety Isolating Transformers General Instruction No 1

NF C66-436:1974 架空线和配件 接线衬套(G)

Insulators and fittings for overhead lines. Bushes for terminal insulators (G).

S.I.703-1968

This Standard applies -tap stationary or portable, single phase or three phase transformers intended generally fdr the supply of a single electrical

ISOLATING TRANSFORMERS

DL/T 378-2010 线技术条件

本标准规定了变压器出线端子用绝缘防护罩的定义、命名、使用条件、试验方法、检验规则、包装、运输和储存。 本标准适用于工频6kV-10kV电力系统中变压器出线端子用的绝缘防护罩

General technical specification of dielectric shield for transformer terminals

DIN 42404:1985 小型标记.安全.可调和小型扼流

This standard applies to terminal markings for small transformers, safety isolating transformers, variable transformers and small chokes. It specifies

Terminal markings for small transformers, safety isolating transformers, variable transformers and small chokes

NF C66-107:1975 架空线和配件 电低于 1000 V 瓷料线(ac)

Insulators and fittings for overhead lines. Insulators of ceramic material for voltages lower than 1000 volts. Terminal insulators (ac).

MNOSZ 4821-1951 高,导言,表面设备-推导及电缆末

NF C66-207:1975 架空线和配件 电低于 1000 V 的玻璃线(AV)

Insulators and fittings for overhead lines. Glass insulators for voltages lower than 1000 V. Terminal insulators (AV).

SIS SEN 14-1951 E-1952 油的维

These recommendations concern rules for judging the con-dition of insulating oil contained in transformers and are in-tended as a supplement to SEN

JIS C 9742:2000 和安全.要求

この規格は,定格供給電圧が交流1000V以下及び500Hz以下の定格周波数をもつ,提携されるかそれとは別の据置形又は可搬形,単相又は多相,空冷形の絶縁変圧器及び安全絶縁変圧器で,次の値の定格出力を超えないものに適用する

Isolating transformers and safety isolating transformers -- Requirements

CNS 6073-1983 杆上引下线

本标准适用于额定电压 6600 V 以下之高压架空电线至杆上变压器一次侧,以交连聚乙烯、乙丙烯(EP)橡胶绝缘之单心引下用高压绝缘电线。注:本标准中{}所附加之数值及单位,系国际单位(SI)制做参考用

High - Voltage Drop Wire for Pole Tramsformer

DIN 46266-1:1988 高线.第1部分:陶瓷

The existing standard issued in 1948 has been brought into line with the present state of the art. The feed-through terminals for bolt connection

High-voltage feed-through terminals; ceramic insulator

T/CEC 407-2020 电力中低线化改造技术规范

本文件规定了电力变压器中低压侧出线绝缘化改造的范围、材料、施工、验收等技术要求。 本文件适用于电力变压器中低压侧的6 kV~35 kV 出线绝缘化改造

Technical specification for insulation transformation of medium and low voltage side outlets of power transformers

DIN 46225:1976 电缆套的冲

Stamped terminals with embrace of the insulation for insulated cables

Stamped terminals with embrace of the insulation for insulated cables

CSN 34 8105-1963

Caps for string insulators

CSA E742-94-CAN/CSA-1994 与安全.通指令第1号

This Standard outlines the requirements that apply, unless otherwise specified in a purchase order or individual standard, to structural quality

Isolating Transformers and Safety Isolating Transformers General Instruction No 1

NF C66-436:1974 架空线和配件 接线衬套(G)

Insulators and fittings for overhead lines. Bushes for terminal insulators (G).

S.I.703-1968

This Standard applies -tap stationary or portable, single phase or three phase transformers intended generally fdr the supply of a single electrical

ISOLATING TRANSFORMERS

编辑:北检院编辑部

我们的优势

选择北检院的六大理由

📚

CMA/CNAS 双认证

旗下实验室具备国家认证认可监督管理委员会CMA资质认定及中国合格评定国家认可委员会CNAS实验室认可,检测报告具有国际公信力。

🔬

1000+ 台套先进设备

配备扫描电镜、气质联用仪、电感耦合等离子体质谱仪等国际先进检测仪器,确保数据精准可靠。

🏢

15000+ 平米实验室

拥有规模化专业检测基地,涵盖材料、化工、食品、环境等多个专业实验室,满足多领域检测需求。

👥

资深技术团队

汇聚材料科学、化学分析、环境工程等领域专家,拥有10年+行业经验,提供专业可靠的检测分析服务。

快速响应机制

标准检测周期短至3个工作日,加急服务24小时出具报告,全程一对一工程师跟进,确保高效交付。

🌎

全国服务网络

总部位于北京,山东设立分部,服务覆盖全国,为20万+客户提供便捷的一站式检测解决方案。

荣誉资质

旗下实验室资质荣誉

CMA 检验检测机构资质认定

CMA 检验检测机构资质认定

国家认证认可监督管理委员会颁发,具备向社会出具具有证明作用数据的资质。

CNAS 实验室认可证书

CNAS 实验室认可证书

中国合格评定国家认可委员会认可,检测结果获国际互认,具有国际公信力。

ISO 质量管理体系认证

ISO 质量管理体系认证

通过ISO 质量管理体系认证,管理体系实现规范化、标准化。

绿色低碳诚信示范创建企业

绿色低碳诚信示范创建企业

荣获绿色低碳诚信示范创建企业称号,践行可持续发展理念,推动绿色低碳转型,助力"双碳"目标实现。

北京市创新型中小企业

北京市"创新型"中小企业

经北京市经济和信息化局认定的创新型中小企业,具备较强创新能力与较高专业化水平,是优质中小企业梯度培育体系的重要基础力量。

北京市专精特新中小企业

北京市"专精特新"中小企业

经北京市经济和信息化局认定的专精特新中小企业,具备专业化、精细化、特色化、新颖化发展特征,在细分领域具有较强竞争优势。

查看全部资质

仪器设备

国际先进检测仪器,确保检测数据精准可靠

查看全部设备

检测流程

标准化流程,高效交付

01

需求沟通

客户提交检测需求,技术顾问一对一沟通,明确检测项目与标准。

02

样品寄送

客户按照规范要求寄送样品,实验室确认样品状态与数量。

03

实验检测

专业工程师按照标准方法进行检测分析,全程质量控制。

04

数据审核

检测数据经多级审核,确保结果准确、可靠、可追溯。

05

报告出具

出具检测报告,支持电子版与纸质版,快递送达。