SAE J590B-1965 汽车转向信号灯
Flashers referred to in this SAE Standard are for nominal I2 or 6 v d.c circuits and are intended to operate at the design load for the turn signal
AUTOMOTIVE TURN SIGNAL FLASHERS
KS R 1047-2005 汽车转向信号灯开关性能
이 규격은 자동차에 사용되는 방향 전환 스위치(이하 스위치라 한다.)의 성능 및 시험 방법
Performance requirement of turn signal switches for automobiles
JIS D 1605:1988 汽车转向信号灯开关性能
Performance requirements of turn signal switches for automobiles
ARMY MIL-DTL-62069 G-2010 汽车转向信号灯24伏直流固态控制装置
CONTROL, DIRECTIONAL SIGNAL LIGHT, AUTOMOTIVE: 24 VOLT DC, SOLID STATE
CNS 5788-1986 汽车用转向信号灯闪光器
本标准适用于汽车用转向信号灯闪光器（以下简称闪光器
Turn Signal Flashers for Automobiles
CNS 6665-1986 汽车用转向信号灯开关之性能试验法
本标准规定汽车用转向信号灯开关（以下简称开关）之性能试验方法
Performance Inspection of Turn Signal Switches for Automobiles
GB 17509-2008 汽车及挂车转向信号灯配光性能
本标准规定了汽车及挂车转向信号灯配光性能的技术要求、试验方法和检验规则。 本标准适用于M、N和O类车辆使用的各种类型转向信号灯。 本标准中，上述转向信号灯也称为装置
Photometric characteristics of direction indicators for motor vehicles and their trailers
GB 17509-1998 汽车和挂车转向信号灯配光性能
本标准规定了汽车和挂车转向信号灯（以下简称为装置）的配光性能要求、配光性能和光色的测量方法以及检验规定。 本标准适用于汽车和挂车使用的转向信号灯
Photometric characteristics of direction indicators for motor vehicles and their trailers
IS 10256-1982 汽车停车、尾灯和转向信号灯安装操作规程
1.1 This standard covers the recommended practice for the installation of stop, tail and turn signal lights for automobiles. 1.1.1 This standard does
GB/T 19123-2015 三轮汽车和低速货车 转向信号灯配光性能
本标准规定了三轮汽车和低速货车用转向信号灯的技术要求、试验方法和检验规则。 本标准适用于三轮汽车和低速货车使用的各种类型的转向信号灯
Tri-wheel vehicles and low-speed goods vehicles.Photometric characteristics of turn signal lamps
SANS 20050:2007 关于批准L类汽车的前后位置灯，制动灯，转向信号灯和后牌照灯照明装置的统一规定
Applies to front position lamps, rear position lamps, stop lamps, direction indicators, and rear-registration-plate illuminating devices for vehicles
Uniform provisions concerning the approval of front position lamps, rear position lamps, stop lamps, direction indicators and rear-registration-plate illuminating devices for vehicles of category L
ANSI/SAE J131-1997 摩托车转向信号灯
Motorcycle Turn Signal Lamps
SAE J131-1983 摩托车转向信号灯
Motorcycle Turn Signal Lamps@ Standard
SAE J131-1997 摩托车转向信号灯
This SAE Standard provides design parameters and general requirements for motorcycle turn signal lamps. It does not apply to mopeds
Motorcycle Turn Signal Lamps
SAE J131-1969 摩托车转向信号灯
MOTORCYCLE AND MOTOR DRIVEN CYCLE TURN SIGNAL LAMPS
SAE J590B-1965 汽车转向信号灯
Flashers referred to in this SAE Standard are for nominal I2 or 6 v d.c circuits and are intended to operate at the design load for the turn signal
AUTOMOTIVE TURN SIGNAL FLASHERS
KS R 1047-2005 汽车转向信号灯开关性能
이 규격은 자동차에 사용되는 방향 전환 스위치(이하 스위치라 한다.)의 성능 및 시험 방법
Performance requirement of turn signal switches for automobiles
JIS D 1605:1988 汽车转向信号灯开关性能
Performance requirements of turn signal switches for automobiles
ARMY MIL-DTL-62069 G-2010 汽车转向信号灯24伏直流固态控制装置
CONTROL, DIRECTIONAL SIGNAL LIGHT, AUTOMOTIVE: 24 VOLT DC, SOLID STATE
CNS 5788-1986 汽车用转向信号灯闪光器
本标准适用于汽车用转向信号灯闪光器（以下简称闪光器
Turn Signal Flashers for Automobiles
CNS 6665-1986 汽车用转向信号灯开关之性能试验法
本标准规定汽车用转向信号灯开关（以下简称开关）之性能试验方法
Performance Inspection of Turn Signal Switches for Automobiles
GB 17509-2008 汽车及挂车转向信号灯配光性能
本标准规定了汽车及挂车转向信号灯配光性能的技术要求、试验方法和检验规则。 本标准适用于M、N和O类车辆使用的各种类型转向信号灯。 本标准中，上述转向信号灯也称为装置
Photometric characteristics of direction indicators for motor vehicles and their trailers
GB 17509-1998 汽车和挂车转向信号灯配光性能
本标准规定了汽车和挂车转向信号灯（以下简称为装置）的配光性能要求、配光性能和光色的测量方法以及检验规定。 本标准适用于汽车和挂车使用的转向信号灯
Photometric characteristics of direction indicators for motor vehicles and their trailers
IS 10256-1982 汽车停车、尾灯和转向信号灯安装操作规程
1.1 This standard covers the recommended practice for the installation of stop, tail and turn signal lights for automobiles. 1.1.1 This standard does
GB/T 19123-2015 三轮汽车和低速货车 转向信号灯配光性能
本标准规定了三轮汽车和低速货车用转向信号灯的技术要求、试验方法和检验规则。 本标准适用于三轮汽车和低速货车使用的各种类型的转向信号灯
Tri-wheel vehicles and low-speed goods vehicles.Photometric characteristics of turn signal lamps
SANS 20050:2007 关于批准L类汽车的前后位置灯，制动灯，转向信号灯和后牌照灯照明装置的统一规定
Applies to front position lamps, rear position lamps, stop lamps, direction indicators, and rear-registration-plate illuminating devices for vehicles
Uniform provisions concerning the approval of front position lamps, rear position lamps, stop lamps, direction indicators and rear-registration-plate illuminating devices for vehicles of category L
ANSI/SAE J131-1997 摩托车转向信号灯
Motorcycle Turn Signal Lamps
SAE J131-1983 摩托车转向信号灯
Motorcycle Turn Signal Lamps@ Standard
SAE J131-1997 摩托车转向信号灯
This SAE Standard provides design parameters and general requirements for motorcycle turn signal lamps. It does not apply to mopeds
Motorcycle Turn Signal Lamps
SAE J131-1969 摩托车转向信号灯
MOTORCYCLE AND MOTOR DRIVEN CYCLE TURN SIGNAL LAMPS
编辑：北检院编辑部
