发布时间:2024-05-27 17:49:26 - 更新时间:2024年06月29日 15:22
点击量:0
本标准规定了灭线磷原药的要求、试验方法以及标志、标签、包装、贮运。 本标准适用于由灭线磷和生产中产生的杂质组成的灭线磷原药。
Ethoprophos technical
本标准规定了灭线磷颗粒剂的要求、试验方法以及标志、标签、包装、贮运。 本标准适用于由灭线磷原药、载体和助剂用吸附法加工成的灭线磷颗粒剂。
Ethoprophos granules
Standard Specification for Phosphor Bronze Wire
1.1x00a0;This specification establishes the requirements for round and flat (square and rectangular) phosphor bronze wire of UNS Alloy Nos. C51000, C52100, and C52400 for general and spring applications. 1.1.1x00a0;Rectangular and square wire of the three alloys are generally available in sizes up to a maximum of 0.188 in. [58201;mm] thick and 1.250 in. [32 mm] wide. 1.1.2x00a0;Round wire from Copper Alloy UNS No. C51000 is generally available in sizes up to 0.500 in. [13 mm] in diameter. 1.2x00a0;Unitsx2014;The values stated in either inch-pound units or in SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the specification. 1.3x00a0;Additional requirements for these products are established in Specification B250/B250M, see Section 3. 1.4x00a0;This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Note 1:x00a0;It is to be understood that this specification is general. Since the product is used for many applications where the requirements of the operations used are too particular to be specified by any of the ordinary mechanical tests, it is frequently advisable to submit samples or drawings to the manufacturer and secure an adjustment of temper to suit the actual application for which the product is intended. Note 2:x00a0;Product in rod, bar and shape form is produced to Specification B139/B139M. 1.5x00a0;This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Specification for Phosphor Bronze Wire
本标准规定了水果和蔬菜中88种农药(见附录A)残留量检测的气相色谱-负化学源质谱筛选检测方法。 本标准适用于胡萝卜、白菜、生姜、苹果、梨、黄桃、草莓、菠菜、西瓜、豇豆、火龙果等蔬菜和水果中88种农药残留量的筛选检测,本标准不适用于橙子等柑橘类水果中灭藻醌残留量的检测。
Screening detection of dichlorvos, tecnazene, ethoprophos 88 pesticide residues in exported fruits and vegetables.QuEChERS-GC-NCI-MS method
Standard Specification for Phosphor Bronze Wire
1.1 This specification establishes the requirements for round, square and flat phosphor bronze wire of UNS Alloy Nos. C51000, C52100, and C52400 for general and spring applications.1.1.1 Rectangular and square wire of the three alloys are generally available in sizes up to a maximum of 0.188 in. [5 mm] thick and 1.250 in. [32 mm] wide.1.1.2 Round wire from Copper Alloy UNS No. C51000 is generally available in sizes up to 0.500 in. [13 mm] in diameter.1.2 The values stated in either inch-pound units or in SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.1.3 Additional requirements for these products are established in Specification B 250/B 250M, see Section .This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.Note 1It is to be understood that this specification is general. Since the product is used for many applications where the requirements of the operations used are too particular to be specified by any of the ordinary mechanical tests, it is frequently advisable to submit samples or drawings to the manufacturer and secure an adjustment of temper to suit the actual application for which the product is intended.Note 2Product in rod, bar and shape form is produced to Specification B 139/B 139M.
Standard Specification for Phosphor Bronze Wire
本标准规定了进出口食品中丙线磷残留量检测的气相色谱测定和液相色谱-质谱/质谱确证方法。 本标准适用于大米、绿豆、菠菜、荷兰豆、柑橘、葡萄、板栗、茶叶、猪肉、鸡肉、猪肝、罗非鱼、蜂蜜中丙线磷残留量的测定和确证。
Determination of ethoprophos residues in foods for import and export
本标准规定了进出口食品中硫线磷残留量的气相色谱测定和气相色谱质谱确证方法。 本标准适用于芦笋、土豆、大葱、苹果、桃、玉米、莽麦、茶叶、食醋、蜂蜜、核桃仁、兔肉、鸡肝和虾仁中硫线磷残留量的测定和确证。
Determination of cadusafos residues in food for import and export
本标准规定了食品中苯线磷残留量的气相色谱-质谱检测方法。 本标准适用于柑桔、苹果、菠菜、大葱、白菜、松子仁、核桃仁、茶叶、蜂蜜、鱼、鸡肾、鸭肝、玉米、糙米、灵芝、辣椒酱中苯线磷残留量的测定和确证。
Determination of fenamiphos residue in foods for import and export.Gas chromatography-mass spectrometry(GC-MS)method
本标准规定了蔬菜、水果中甲胺磷等 20 种农药的最大残留限量。 本标准适用于表 1 所列农药对应的蔬菜、水果。
本标准规定了蔬菜、水果中甲胺磷等 20 种农药的最大残留限量。 本标准适用于表 1 所列农药对应的蔬菜、水果。
本标准规定了蔬菜、水果中甲胺磷等 20 种农药的最大残留限量。 本标准适用于表 1 所列农药对应的蔬菜、水果。
本标准规定了蔬菜、水果中甲胺磷等 20 种农药的最大残留限量。 本标准适用于表 1 所列农药对应的蔬菜、水果。
本标准规定了土壤中灭线磷残留量气相色谱测定方法。本标准适用于土壤中灭线磷残留量的测定。本标准的方法检出限为0.001mg/kg。
COMMISSION DIRECTIVE amending Council Directive 91/414/EEC to include fenamiphos and ethephon as active substances
Standard Specification for Phosphor Bronze Wire
COMMISSION DIRECTIVE amending Council Directives 86/362/EEC, 86/363/EEC and 90/642/EEC as regards maximum residue levels for fenamiphos
Maximum residue limits of alachlor,carbofuran,chlorthalonil,fenamiphos and metolachlor in peanuts
Standard Specification for Phosphor Bronze Wire
Some oils are formulated with organo-metallic additives, which act, for example, as detergents, antioxidants, and antiwear agents. Some of these additives contain one or more of these elements: calcium, phosphorus, sulfur, and zinc. This test method provides a means of determining the concentrations of these elements, which in turn provides an indication of the additive content of these oils. This test method is primarily intended to be used at a manufacturing location for monitoring of additive elements in lubricating oils. It can also be used in central and research laboratories.1.1 This test method covers the quantitative determination of additive elements in unused lubricating oils, as shown in Table 1. 1.2 This test method is limited to the use of energy dispersive X-ray fluorescence (EDXRF) spectrometers employing an X-ray tube for excitation in conjunction with the ability to separate the signals of adjacent elements. 1.3 This test method uses interelement correction factors calculated from empirical calibration data. 1.4 This test method is not suitable for the determination of magnesium and copper at the concentrations present in lubricating oils. 1.5 This test method excludes lubricating oils that contain chlorine or barium as an additive element. 1.6 This test method can be used by persons who are not skilled in X-ray spectrometry. It is intended to be used as a routine test method for production control analysis. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations to use.
Standard Test Method for Determination of Phosphorus, Sulfur, Calcium, and Zinc in Lubrication Oils by Energy Dispersive X-ray Fluorescence Spectroscopy
Method for the determination of ethoprophosresidues in cereals for export
本标准适用于经展伸加工,其断面成圆形之磷青铜线(以下简称为线)。
Phosphor Bronze Wires
Provides the accepted common name for the chemical compound given. Includes the use of the common name and the physical and chemical properties of the chemical compound.
Common Name for the Pest Control Chemical O-(2,4 Dichlorophenyl) O,O- diethyl Phosphorothioate "Dichlofenthion"