服务热线:400-635-0567

坐便器、水箱、小便器排水装置检测

发布时间:2023-11-01 20:56:27

点击量:0

军工检测 其他检测

JC 707-1997 便配件

Fitting of water closet

JC/T 2118-2012 便污口密封

本标准规定了坐便器排污口密封装置的术语和定义、分类、技术要求、试验方法、检验规则、标志、使用说明书、包装、运输及贮存等。本标准适用于坐便器排污口密封装置

Sealing device of sewage outfall for toilet installation

JC/T 551-1994 便配件—阀密封及寿命试验方法

Toilet low water tank accessories - drain valve seal and life test method

MNOSZ 5242-1953 运输管道配件.便连接

BS EN 14055:2010 WC和便冲洗

WC and urinal flushing cisterns

EN 14055:2010 WC和便冲刷

This European Standard specifies design, performance requirements and the test methods for WC and urinal flushing cisterns with flushing mechanism

WC and urinal flushing cisterns (Incorporates Amendment A1: 2015)

EN 14055:2018 WC和便冲刷

This European Standard specifies design@ performance characteristics and the test methods for WC and urinal flushing cisterns with flushing mechanism@

WC and urinal flushing cisterns

DIN EN 997:2018-12 带集成存弯的便便套件

WC pans and WC suites with integral trap; German version EN 997:2018

UNE-EN 997:2019 带集成存弯的便便套件

WC pans and WC suites with integral trap

JC 987-2005 便配件

本标准规定了水箱配件的术语和定义、要求、试验方法、检验规则、标志、包装、运输和贮存。 本标准适用于安装在静压力不大于0.6MPa的供水管路上的靠水的重力作用的为各种便器配套的水箱配件

Fittings for water closet flush tank

JG/T 3040.1-1997 大便冲洗.液压式配件

本标准规定了液压式水箱配件的分类、技术要求、试验方法、检验规则及标志、包装、运输、贮存 本标准适用于以常温水作为介质的液压式大便器高(低)位水箱配件

Flush device of water closet.Fittings of hydraulic water tank

T/FJASI 2-2018 感应式尿便控制(总成)

本标准由:福州大学、福建洁利来智能厨卫股份有限公司等单位共同起草,并首次对感应式尿水分排小便器的给排水控制器(总成)以标准的形式,对产品的原理、分类、产品要求以及试验方法、检验规则和包装、运输和贮藏等内容进行了规范。其基本框架如下: 前言  1 范围  2 规范性引用文件1 3 术语和定义

Inductive urinal of urine-water separate discharge—controller (assembly) for water supply and drainage

IS 2326-1970 便自动冲洗规范

This standard lays down the materials, nominal sizes, construction and performance requirements for automatic flushing cisterns of the type used

BS EN 997:2018 跟踪更改 带集成存弯的便便套件

This standard specifies constructional and performance requirements together with test methods for close-coupled suites, one-piece and independent WC

Tracked Changes. WC pans and WC suites with integral trap

GB 25502-2017 便效限定值及效等级

本标准规定了坐便器的水效限定值、节水评价值、水效等级和试验方法。 本标准适用于安装在建筑设施内冷水管路上,供水压力不大于0.6 MPa条件下使用的各类坐便器的水效评价

Minimum allowable values of water efficiency and water efficiency grades for water closets

JC 707-1997 便配件

Fitting of water closet

JC/T 2118-2012 便污口密封

本标准规定了坐便器排污口密封装置的术语和定义、分类、技术要求、试验方法、检验规则、标志、使用说明书、包装、运输及贮存等。本标准适用于坐便器排污口密封装置

Sealing device of sewage outfall for toilet installation

JC/T 551-1994 便配件—阀密封及寿命试验方法

Toilet low water tank accessories - drain valve seal and life test method

MNOSZ 5242-1953 运输管道配件.便连接

BS EN 14055:2010 WC和便冲洗

WC and urinal flushing cisterns

EN 14055:2010 WC和便冲刷

This European Standard specifies design, performance requirements and the test methods for WC and urinal flushing cisterns with flushing mechanism

WC and urinal flushing cisterns (Incorporates Amendment A1: 2015)

EN 14055:2018 WC和便冲刷

This European Standard specifies design@ performance characteristics and the test methods for WC and urinal flushing cisterns with flushing mechanism@

WC and urinal flushing cisterns

DIN EN 997:2018-12 带集成存弯的便便套件

WC pans and WC suites with integral trap; German version EN 997:2018

UNE-EN 997:2019 带集成存弯的便便套件

WC pans and WC suites with integral trap

JC 987-2005 便配件

本标准规定了水箱配件的术语和定义、要求、试验方法、检验规则、标志、包装、运输和贮存。 本标准适用于安装在静压力不大于0.6MPa的供水管路上的靠水的重力作用的为各种便器配套的水箱配件

Fittings for water closet flush tank

JG/T 3040.1-1997 大便冲洗.液压式配件

本标准规定了液压式水箱配件的分类、技术要求、试验方法、检验规则及标志、包装、运输、贮存 本标准适用于以常温水作为介质的液压式大便器高(低)位水箱配件

Flush device of water closet.Fittings of hydraulic water tank

T/FJASI 2-2018 感应式尿便控制(总成)

本标准由:福州大学、福建洁利来智能厨卫股份有限公司等单位共同起草,并首次对感应式尿水分排小便器的给排水控制器(总成)以标准的形式,对产品的原理、分类、产品要求以及试验方法、检验规则和包装、运输和贮藏等内容进行了规范。其基本框架如下: 前言  1 范围  2 规范性引用文件1 3 术语和定义

Inductive urinal of urine-water separate discharge—controller (assembly) for water supply and drainage

IS 2326-1970 便自动冲洗规范

This standard lays down the materials, nominal sizes, construction and performance requirements for automatic flushing cisterns of the type used

BS EN 997:2018 跟踪更改 带集成存弯的便便套件

This standard specifies constructional and performance requirements together with test methods for close-coupled suites, one-piece and independent WC

Tracked Changes. WC pans and WC suites with integral trap

GB 25502-2017 便效限定值及效等级

本标准规定了坐便器的水效限定值、节水评价值、水效等级和试验方法。 本标准适用于安装在建筑设施内冷水管路上,供水压力不大于0.6 MPa条件下使用的各类坐便器的水效评价

Minimum allowable values of water efficiency and water efficiency grades for water closets

检测流程
填写并提交定制服务需求表
技术评估和方案讨论
对选定的试验方法进行报价
合同签定与付款
按期交付检测报告和相关数据
想了解更多检测项目
请点击咨询在线工程师
点击咨询
联系我们
服务热线:400-635-0567
地址:北京市丰台区南三环西路16号2号楼27层
邮编:10000
总机:400-635-0567
联系我们

服务热线:400-635-0567

投诉建议:010-82491398

报告问题解答:010-8646-0567-8

周期、价格等

咨询

技术咨询