JK型交流低压电控设备检测

JB/T 9666-1999 JK型交流低压电控设备

　　本标准规定了JK型交流低压电控设备的产品分类、技术要求、试验方法、检验规则、标志、包装与运输等，适用于交流50Hz，额定电压不超过660V，以低压电器为主组成的户内用电控设备

JK type a.c.low-voltage control equipment

JB/T 8948-1999 电控制设备用低压直流电源

　　本标准规定了电控设备用低压直流电源的产品型号、技术要求、试验方法、检验股则、产品包装、运输及贮存的要求等。 　　本标准适用于额定频率为50Hz或60Hz、400Hz，额定电压不超过1000V及额定电压为直流不超过400V供电的、输出额定直流电压不超过400V，额定功率不大于30kW的低压开关

Low-voltage power supple d.c.output for electric control equipment

NF C63-081:1987 工业低压开关和控制设备.近距离电感应开关.Ａ型交流式2端子

LOW VOLTAGE SWITCHGEAR AND CONTROLGEAR FOR INDUSTRIAL USE. INDUCTIVE PROXIMITY SWITCHES. FORM A,FOR ALTERNATING CURRENT,2 TERMINALS. (EUROPEAN STANDARD EN 50 036).

NF C63-082:1987 工业低压开关和控制设备.近距离电感应开关.Ｃ型.交流式2端子

LOW VOLTAGE SWITCHGEAR AND CONTROLGEAR FOR INDUSTRIAL USE. INDUCTIVE PROXIMITY SWITCHES. FORM C,FOR ALTERNATING CURRENT,2 TERMINALS. (EUROPEAN STANDARD EN 50 037).

NF C63-083:1987 工业低压开关和控制设备.近距离电感应开关.Ｄ型.交流式2端子

LOW-VOLTAGE SWITCHGEAR AND CONTROLGEAR FOR INDUSTRIAL USE. INDUCTIVE PROXIMITY SWITCHES. FORM D,FOR ALTERNATING CURRENT,2 TERMINALS. (EUROPEAN STANDARD EN 50 038).

NF C64-150:1985 交流高压开关设备和控制装置.高压交流电接触器

A.C. high-voltage switchgear and controlgear. High-voltage alternating current contactors.

JB/T 8456-2005 低压直流成套开关设备和控制设备

本标准规定了低压直流成套开关设备和控制设备(以下简称直流设备)的适用范围、术语、产品分类、技术要求、检验、标志、包装、运输与贮存。 本标准适用于户内正常使用条件下直流额定电压不超过1500V的直流设备，包括型式试验的成套设备(TTA)和部分型式试验的成套设备(PTTA

Low-voltage D.C switchgear and controlgear assemblies

T/WHDQHX 001-2020 智能型低压成套电力开关设备和控制设备

       《智能型低压成套电力开关设备和控制设备》作为“武汉名品”评价认证依据，主要技术内容简述：配电柜做到安全可靠，不仅在全方位覆盖各行业低压配电需求的同时，亦能完美契合石油石化、采矿、核能等高安全标准行业的特定需求;针对

Low-voltage switchgear and controlgear for intelligent assemblies

AIR FORCE A-A-59575-2004 便携灯设备(危险地点使用,低压交流控制柜)

This commercial item description covers a 120 VAC powered fluorescent light fixture mounted on wheels to provide illumination on the bottom side

LIGHT UNIT, PORTABLE, (HAZARDOUS LOCATION USE, FOR INSIDE PAINT SPRAY BOOTH)

BS EN 62271-212:2022 高压开关设备和控制设备 交流电压高达 52kV 的配电变电站（CEADS）的紧凑型设备组件

1   Scope This part of IEC 62271 specifies the service conditions, rated characteristics, general structural requirements and test methods

High-voltage switchgear and controlgear - Compact Equipment Assembly for Distribution Substation (CEADS) for AC voltages up to 52 kV

AS/NZS 3947.4.3:2000 低压开关设备和控制设备．电流接触器和电动起动器．非电动机负荷用交流半导体控制器和电流接触器

Applies to a.c. semiconductor non-motor load controllers and contactors intended for performing electrical operations by changing the state of a.c

Low-voltage switchgear and controlgear - Contactors and motor-starters - A.C. semiconductor controllers and contactors for non-motor loads

AS 2799:1992 电阻焊设备．单相交流变压器型

Specifies and defines the characteristics of single-phase resistance welding equipment. It includes the information required on the equipment

Resistance welding equipment - Single-phase a.c. transformer type

JB/T 8456-2017 低压直流成套开关设备和控制设备

Low voltage DC complete switchgear and control equipment

AS/NZS IEC 60947.5.9:2015 低压开关设备和控制设备 控制电路设备和开关元件 流量开关

Adopts IEC 60947-5-9, Ed. 1.0 (2006) which applies to flow rate switches that sense the rate of flow of a gas, a liquid or a granular solid

SANS 62271-100:2009 高压开关设备及控制设备.第100部分:交流电流断路器

Applicable to a.c. circuit-breakers designed for indoor or outdoor installation and for operation at frequencies of 50 Hz and 60 Hz on systems having

High-voltage switchgear and controlgear Part 100: Alternating-current circuit-breakers

JB/T 9666-1999 JK型交流低压电控设备

　　本标准规定了JK型交流低压电控设备的产品分类、技术要求、试验方法、检验规则、标志、包装与运输等，适用于交流50Hz，额定电压不超过660V，以低压电器为主组成的户内用电控设备

JK type a.c.low-voltage control equipment

JB/T 8948-1999 电控制设备用低压直流电源

　　本标准规定了电控设备用低压直流电源的产品型号、技术要求、试验方法、检验股则、产品包装、运输及贮存的要求等。 　　本标准适用于额定频率为50Hz或60Hz、400Hz，额定电压不超过1000V及额定电压为直流不超过400V供电的、输出额定直流电压不超过400V，额定功率不大于30kW的低压开关

Low-voltage power supple d.c.output for electric control equipment

NF C63-081:1987 工业低压开关和控制设备.近距离电感应开关.Ａ型交流式2端子

LOW VOLTAGE SWITCHGEAR AND CONTROLGEAR FOR INDUSTRIAL USE. INDUCTIVE PROXIMITY SWITCHES. FORM A,FOR ALTERNATING CURRENT,2 TERMINALS. (EUROPEAN STANDARD EN 50 036).

NF C63-082:1987 工业低压开关和控制设备.近距离电感应开关.Ｃ型.交流式2端子

LOW VOLTAGE SWITCHGEAR AND CONTROLGEAR FOR INDUSTRIAL USE. INDUCTIVE PROXIMITY SWITCHES. FORM C,FOR ALTERNATING CURRENT,2 TERMINALS. (EUROPEAN STANDARD EN 50 037).

NF C63-083:1987 工业低压开关和控制设备.近距离电感应开关.Ｄ型.交流式2端子

LOW-VOLTAGE SWITCHGEAR AND CONTROLGEAR FOR INDUSTRIAL USE. INDUCTIVE PROXIMITY SWITCHES. FORM D,FOR ALTERNATING CURRENT,2 TERMINALS. (EUROPEAN STANDARD EN 50 038).

NF C64-150:1985 交流高压开关设备和控制装置.高压交流电接触器

A.C. high-voltage switchgear and controlgear. High-voltage alternating current contactors.

JB/T 8456-2005 低压直流成套开关设备和控制设备

本标准规定了低压直流成套开关设备和控制设备(以下简称直流设备)的适用范围、术语、产品分类、技术要求、检验、标志、包装、运输与贮存。 本标准适用于户内正常使用条件下直流额定电压不超过1500V的直流设备，包括型式试验的成套设备(TTA)和部分型式试验的成套设备(PTTA

Low-voltage D.C switchgear and controlgear assemblies

T/WHDQHX 001-2020 智能型低压成套电力开关设备和控制设备

       《智能型低压成套电力开关设备和控制设备》作为“武汉名品”评价认证依据，主要技术内容简述：配电柜做到安全可靠，不仅在全方位覆盖各行业低压配电需求的同时，亦能完美契合石油石化、采矿、核能等高安全标准行业的特定需求;针对

Low-voltage switchgear and controlgear for intelligent assemblies

AIR FORCE A-A-59575-2004 便携灯设备(危险地点使用,低压交流控制柜)

This commercial item description covers a 120 VAC powered fluorescent light fixture mounted on wheels to provide illumination on the bottom side

LIGHT UNIT, PORTABLE, (HAZARDOUS LOCATION USE, FOR INSIDE PAINT SPRAY BOOTH)

BS EN 62271-212:2022 高压开关设备和控制设备 交流电压高达 52kV 的配电变电站（CEADS）的紧凑型设备组件

1   Scope This part of IEC 62271 specifies the service conditions, rated characteristics, general structural requirements and test methods

High-voltage switchgear and controlgear - Compact Equipment Assembly for Distribution Substation (CEADS) for AC voltages up to 52 kV

AS/NZS 3947.4.3:2000 低压开关设备和控制设备．电流接触器和电动起动器．非电动机负荷用交流半导体控制器和电流接触器

Applies to a.c. semiconductor non-motor load controllers and contactors intended for performing electrical operations by changing the state of a.c

Low-voltage switchgear and controlgear - Contactors and motor-starters - A.C. semiconductor controllers and contactors for non-motor loads

AS 2799:1992 电阻焊设备．单相交流变压器型

Specifies and defines the characteristics of single-phase resistance welding equipment. It includes the information required on the equipment

Resistance welding equipment - Single-phase a.c. transformer type

JB/T 8456-2017 低压直流成套开关设备和控制设备

Low voltage DC complete switchgear and control equipment

AS/NZS IEC 60947.5.9:2015 低压开关设备和控制设备 控制电路设备和开关元件 流量开关

Adopts IEC 60947-5-9, Ed. 1.0 (2006) which applies to flow rate switches that sense the rate of flow of a gas, a liquid or a granular solid

SANS 62271-100:2009 高压开关设备及控制设备.第100部分:交流电流断路器

Applicable to a.c. circuit-breakers designed for indoor or outdoor installation and for operation at frequencies of 50 Hz and 60 Hz on systems having

High-voltage switchgear and controlgear Part 100: Alternating-current circuit-breakers