服务热线:400-635-0567

物联网电流变送器检测

发布时间:2023-11-28 17:45:45

点击量:0

军工检测 其他检测

GB/T 34070-2017 规范

Standard of electrical measuring transmitters for internet of things

GB/T 34037-2017 差压规范

Specification of differential pressure transmitter for internet of things

GB/T 34073-2017 压力规范

Specification of pressure transmitter for internet of things

GB/T 34072-2017 温度规范

Specification of temperature transmitter for internet of things

JJG 126-2022 工频交量测量

Power Frequency AC Power Measuring Transmitter

JJG 126-1995 交换为直工测量检定规程

Verification Regulation of Measuring Transducers for Converting a.c.Electrical Quantities into d.c.Electrical Quantities

AIR FORCE QPL-38144-QPD-2012 量、燃料

Transmitter, Rate of Flow, Fuel

ARMY MS24537 REV C VALID NOTICE 3-2000 24伏特直阻温度

MS24537C remains inactive for new design, however, the document is valid for acthewhen needed

TRANSMITTER, TEMPERATURE ELECTRICAL RESISTANCE - 24 VOLT DC

ARMY MS24537 REV C-1967 24伏特直阻温度

NOMINAL CURRLVT GIVEN IN CALIBRATION TASLE IS WED ON 360 OHUS RESISTANCE.LN SERIES WITH TRANUIITTER AND 28.5 VOLTS APPLIED ACROSS THE CWBINATION

TRANSMITTER, TEMPERATURE ELECTRICAL RESISTANCE - 24 VOLT DC

BS ISO/IEC 30144:2020 (IOT) 支持站的线传感络系统

Internet of things (IOT). Wireless sensor network system supporting electrical power substation

DS/ISO/IEC 30144:2020 (IoT) 支持站的线传感络系统

Internet of things (IoT) – Wireless sensor network system supporting electrical power substation

T/CASME 115-2022 气化设备自耦技术条件

本文件规定了物联网电气化设备2×27.5 kV自耦变压器的术语和定义、性能参数、技术要求、试验、标志、起吊、运输及贮存的相关要求

Technical conditions of autotransformer for internet of things electrification equipment

JJG 461-1986 靶式检定规程

Verification Regulation of Target(Bluff Body)Type Flow Transducer

AIR FORCE QPL-5583-25-2002 28伏特直位置

This list has been prepared for use by or for the Government in the acquisition of products covered by the subject specification and such listing

TRANSMITTER, POSITION, 28 VOLTS DC

GB/T 3859.3-2013 半导体 通用要求和换相 第1-3部分:

GB/T 3859的本部分规定了变流变压器不同于通用电力变压器的特性。应注意到,整流变压器运行时,通常流通着非正弦波电流。在单拍联结中,每个阀侧绕组的电流均含有直流分量,在设计和试验时应特别注意。在某些情况下,外部短路和元件故障会产生异常的应力,因而有必要进行特殊设计。一些类型的变压器正常运行时的

Semiconductor converters.General requirements and line commutated converters.Part 1-3:Transformers and reactors

GB/T 34070-2017 规范

Standard of electrical measuring transmitters for internet of things

GB/T 34037-2017 差压规范

Specification of differential pressure transmitter for internet of things

GB/T 34073-2017 压力规范

Specification of pressure transmitter for internet of things

GB/T 34072-2017 温度规范

Specification of temperature transmitter for internet of things

JJG 126-2022 工频交量测量

Power Frequency AC Power Measuring Transmitter

JJG 126-1995 交换为直工测量检定规程

Verification Regulation of Measuring Transducers for Converting a.c.Electrical Quantities into d.c.Electrical Quantities

AIR FORCE QPL-38144-QPD-2012 量、燃料

Transmitter, Rate of Flow, Fuel

ARMY MS24537 REV C VALID NOTICE 3-2000 24伏特直阻温度

MS24537C remains inactive for new design, however, the document is valid for acthewhen needed

TRANSMITTER, TEMPERATURE ELECTRICAL RESISTANCE - 24 VOLT DC

ARMY MS24537 REV C-1967 24伏特直阻温度

NOMINAL CURRLVT GIVEN IN CALIBRATION TASLE IS WED ON 360 OHUS RESISTANCE.LN SERIES WITH TRANUIITTER AND 28.5 VOLTS APPLIED ACROSS THE CWBINATION

TRANSMITTER, TEMPERATURE ELECTRICAL RESISTANCE - 24 VOLT DC

BS ISO/IEC 30144:2020 (IOT) 支持站的线传感络系统

Internet of things (IOT). Wireless sensor network system supporting electrical power substation

DS/ISO/IEC 30144:2020 (IoT) 支持站的线传感络系统

Internet of things (IoT) – Wireless sensor network system supporting electrical power substation

T/CASME 115-2022 气化设备自耦技术条件

本文件规定了物联网电气化设备2×27.5 kV自耦变压器的术语和定义、性能参数、技术要求、试验、标志、起吊、运输及贮存的相关要求

Technical conditions of autotransformer for internet of things electrification equipment

JJG 461-1986 靶式检定规程

Verification Regulation of Target(Bluff Body)Type Flow Transducer

AIR FORCE QPL-5583-25-2002 28伏特直位置

This list has been prepared for use by or for the Government in the acquisition of products covered by the subject specification and such listing

TRANSMITTER, POSITION, 28 VOLTS DC

GB/T 3859.3-2013 半导体 通用要求和换相 第1-3部分:

GB/T 3859的本部分规定了变流变压器不同于通用电力变压器的特性。应注意到,整流变压器运行时,通常流通着非正弦波电流。在单拍联结中,每个阀侧绕组的电流均含有直流分量,在设计和试验时应特别注意。在某些情况下,外部短路和元件故障会产生异常的应力,因而有必要进行特殊设计。一些类型的变压器正常运行时的

Semiconductor converters.General requirements and line commutated converters.Part 1-3:Transformers and reactors

检测流程
填写并提交定制服务需求表
技术评估和方案讨论
对选定的试验方法进行报价
合同签定与付款
按期交付检测报告和相关数据
想了解更多检测项目
请点击咨询在线工程师
点击咨询
联系我们
服务热线:400-635-0567
地址:北京市丰台区南三环西路16号2号楼27层
邮编:10000
总机:400-635-0567
联系我们

服务热线:400-635-0567

投诉建议:010-82491398

报告问题解答:010-8646-0567-8

周期、价格等

咨询

技术咨询