工作场所环境检测

📅 发布时间:2024-05-27 👤 来源:北检院 👁 阅读:

TCVN 5704-1993 .飞尘测定方法

Workplace atmospheres.Method for determination of dust

ANSI Z4.1-1986 卫生的最低要求

This standard applies to all permanent places of employment, except where domestic, mining or common carrier transportation work only is performed

Sanitation - In Places of Employment - Minimum Requirements

DB51/T 1617-2013 政务服务中心 要求

Environmental requirements for workplaces in government service centers

TIS 2574-2012 内的大气颗粒物采样和分析

Airborne particulate matter sampling and analysis in workplace environment

ISO/TR 14294:2011 .皮肤暴露度测量原则和方法

Workplace atmospheres - Measurement of dermal exposure - Principles and methods

DIN EN 481:1993 .测量空气中微粒粒度的定义

The document defines the inspirable and respirable fractions of the dust at the workplace

Workplaces atmospheres; size fraction definitions for measurement of airborne particles; German version EN 481:1993

AS 3640:2004 .可吸入粉尘的采样和重量分析测定法

Specifies a gravimetric method for the collection and determination of inhalable dust. The aim of this revision is to align the Standard more closely

Workplace atmospheres - Method for sampling and gravimetric determination of inhalable dust

BS EN 1231:1997 .短期检测管测量系统.要求和试验方法

This European Standard specifies performance requirements and test methods under prescribed laboratory conditions for length of stain detector tubes

Workplace atmospheres - Short term detector tube measurement systems - Requirements and test methods

DIN EN 482:2006 .化学试剂测量用程序性能的一般要求

This document specifies general performance requirements for procedures for determination of the concentration of chemical agents in workplace

Workplace atmospheres - General requirements for the performance of procedures for the measurement of chemical agents; English version of DIN EN 482:2006-10

BS EN ISO 17621:2015 .短期检测管测量系统.要求和试验方法

Workplace atmospheres. Short term detector tube measurement systems. Requirements and test methods

BS EN 13205:2002 .空气中粒子浓度测量用仪器的性能评定

Workplace atmospheres - Assessment of performance of instruments for measurement of airborne particle concentrations

ASTM D4600-95(2000)e1 苯测定的标准试验方法.中的可溶性颗粒物

1.1 This test method describes the sampling and gravimetric determination of benzene-soluble particulate matter that has become airborne

Standard Test Method for Determination of Benzene-Soluble Particulate Matter in Workplace Atmospheres

ASTM D5578-04(2015 用于测定氧乙烷的标准试验方法 (HBr衍生法)

5.1 Ethylene oxide is a major industrial chemical

Standard Test Method for Determination of Ethylene Oxide in Workplace Atmospheres (HBr Derivatization Method)

EN 1076:1997 .气体和蒸气的泵吸附管的测定.要求和试验方法

Workplace Atmospheres - Pumped Sorbent Tubes for the Determination of Gases and Vapours - Requirements and Test Methods

ASTM D4185-17 通过火焰原子吸收测量中金属的标准测试方法

1.1 This test method covers the collection, dissolution, and determination of trace metals in workplace atmospheres, by flame atomic absorption

Standard Test Method for Measurement of Metals in Workplace Atmospheres by Flame Atomic Absorption Spectrophotometry

TCVN 5704-1993 .飞尘测定方法

Workplace atmospheres.Method for determination of dust

ANSI Z4.1-1986 卫生的最低要求

This standard applies to all permanent places of employment, except where domestic, mining or common carrier transportation work only is performed

Sanitation - In Places of Employment - Minimum Requirements

DB51/T 1617-2013 政务服务中心 要求

Environmental requirements for workplaces in government service centers

TIS 2574-2012 内的大气颗粒物采样和分析

Airborne particulate matter sampling and analysis in workplace environment

ISO/TR 14294:2011 .皮肤暴露度测量原则和方法

Workplace atmospheres - Measurement of dermal exposure - Principles and methods

DIN EN 481:1993 .测量空气中微粒粒度的定义

The document defines the inspirable and respirable fractions of the dust at the workplace

Workplaces atmospheres; size fraction definitions for measurement of airborne particles; German version EN 481:1993

AS 3640:2004 .可吸入粉尘的采样和重量分析测定法

Specifies a gravimetric method for the collection and determination of inhalable dust. The aim of this revision is to align the Standard more closely

Workplace atmospheres - Method for sampling and gravimetric determination of inhalable dust

BS EN 1231:1997 .短期检测管测量系统.要求和试验方法

This European Standard specifies performance requirements and test methods under prescribed laboratory conditions for length of stain detector tubes

Workplace atmospheres - Short term detector tube measurement systems - Requirements and test methods

DIN EN 482:2006 .化学试剂测量用程序性能的一般要求

This document specifies general performance requirements for procedures for determination of the concentration of chemical agents in workplace

Workplace atmospheres - General requirements for the performance of procedures for the measurement of chemical agents; English version of DIN EN 482:2006-10

BS EN ISO 17621:2015 .短期检测管测量系统.要求和试验方法

Workplace atmospheres. Short term detector tube measurement systems. Requirements and test methods

BS EN 13205:2002 .空气中粒子浓度测量用仪器的性能评定

Workplace atmospheres - Assessment of performance of instruments for measurement of airborne particle concentrations

ASTM D4600-95(2000)e1 苯测定的标准试验方法.中的可溶性颗粒物

1.1 This test method describes the sampling and gravimetric determination of benzene-soluble particulate matter that has become airborne

Standard Test Method for Determination of Benzene-Soluble Particulate Matter in Workplace Atmospheres

ASTM D5578-04(2015 用于测定氧乙烷的标准试验方法 (HBr衍生法)

5.1 Ethylene oxide is a major industrial chemical

Standard Test Method for Determination of Ethylene Oxide in Workplace Atmospheres (HBr Derivatization Method)

EN 1076:1997 .气体和蒸气的泵吸附管的测定.要求和试验方法

Workplace Atmospheres - Pumped Sorbent Tubes for the Determination of Gases and Vapours - Requirements and Test Methods

ASTM D4185-17 通过火焰原子吸收测量中金属的标准测试方法

1.1 This test method covers the collection, dissolution, and determination of trace metals in workplace atmospheres, by flame atomic absorption

Standard Test Method for Measurement of Metals in Workplace Atmospheres by Flame Atomic Absorption Spectrophotometry

编辑:北检院编辑部

我们的优势

选择北检院的六大理由

📚

CMA/CNAS 双认证

具备国家认证认可监督管理委员会CMA资质认定及中国合格评定国家认可委员会CNAS实验室认可,检测报告具有国际公信力。

🔬

1000+ 台套先进设备

配备扫描电镜、气质联用仪、电感耦合等离子体质谱仪等国际先进检测仪器,确保数据精准可靠。

🏢

15000+ 平米实验室

拥有规模化专业检测基地,涵盖材料、化工、食品、环境等多个专业实验室,满足多领域检测需求。

👥

资深技术团队

汇聚材料科学、化学分析、环境工程等领域专家,拥有10年+行业经验,提供专业可靠的检测分析服务。

快速响应机制

标准检测周期短至3个工作日,加急服务24小时出具报告,全程一对一工程师跟进,确保高效交付。

🌎

全国服务网络

总部位于北京,山东设立分部,服务覆盖全国,为20万+客户提供便捷的一站式检测解决方案。

荣誉资质

旗下实验室资质荣誉

CMA 检验检测机构资质认定

CMA 检验检测机构资质认定

国家认证认可监督管理委员会颁发,具备向社会出具具有证明作用数据的资质。

CNAS 实验室认可证书

CNAS 实验室认可证书

中国合格评定国家认可委员会认可,检测结果获国际互认,具有国际公信力。

ISO 质量管理体系认证

ISO 质量管理体系认证

通过ISO 质量管理体系认证,管理体系实现规范化、标准化。

绿色低碳诚信示范创建企业

绿色低碳诚信示范创建企业

荣获绿色低碳诚信示范创建企业称号,践行可持续发展理念,推动绿色低碳转型,助力"双碳"目标实现。

北京市创新型中小企业

北京市"创新型"中小企业

经北京市经济和信息化局认定的创新型中小企业,具备较强创新能力与较高专业化水平,是优质中小企业梯度培育体系的重要基础力量。

北京市专精特新中小企业

北京市"专精特新"中小企业

经北京市经济和信息化局认定的专精特新中小企业,具备专业化、精细化、特色化、新颖化发展特征,在细分领域具有较强竞争优势。

查看全部资质

仪器设备

国际先进检测仪器,确保检测数据精准可靠

查看全部设备

检测流程

标准化流程,高效交付

01

需求沟通

客户提交检测需求,技术顾问一对一沟通,明确检测项目与标准。

02

样品寄送

客户按照规范要求寄送样品,实验室确认样品状态与数量。

03

实验检测

专业工程师按照标准方法进行检测分析,全程质量控制。

04

数据审核

检测数据经多级审核,确保结果准确、可靠、可追溯。

05

报告出具

出具CMA/CNAS权威检测报告,支持电子版与纸质版,快递送达。