DLA MIL-DTL-55302/90 F-2008 印刷电路组件和附件用连接器:极性接触件(0.100英寸间隔)直角式插座
CONNECTORS, PRINTED CIRCUIT SUBASSEMBLY AND ACCESSORIES: RECEPTACLE, RIGHT ANGLE, HERMAPHRODITIC CONTACT (.100 INCH SPACING)
T/CEEIA 517-2021 嵌入式插座
本文件规定了嵌入式插座的额定值、标志、尺寸检查、防触电保护、结构、电气性能、机械性能等技术要求。 本文件适用于户内或户外使用的、家用和类似用途的、可拆线或不可拆线、带或不带接地的、额定电压在交流50 V以上但不超过440 V、额定电流不超过16 A的嵌入式插座
Built-in socket-outlets
DLA MS90555 REV E-2003 壁式电连接器插座 等级1(电源插座)
Dimensions are in inches. Unless otherwise specified, tolerance is ± .016. For protective cover, see standard MS90563. F dimension from the front
CONNECTOR, RECEPTACLE, ELECTRICAL, WALL MOUNTING, CLASS L (POWER SOURCE RECEPTACLE)
NAVY MS24011 REV E VALID NOTICE 1-1993 20号转接18插座式接点矩形插头座
MS24011E, dated 6 December 1971, has been reviewed and determined valid for use in acquisition
CONNECTOR, RECTANGULAR, ELECTRICAL, RACK AND PANEL, 18, SIZE 20 SOCKET CONTACTS
NAVY MS24011 REV E-1971 20号转接18插座式接点矩形插头座
Dimensions are in inches
CONNECTOR, RECTANGULAR, ELECTRICAL, RACK AND PANEL, 18, SIZE 20 SOCKET CONTACTS
DLA MS90555 REV F (2)-2011 连接器，插座，电气，壁挂式，L 类（电源插座）
CONNECTOR, RECEPTACLE, ELECTRICAL, WALL MOUNTING, CLASS L (POWER SOURCE RECEPTACLE)
BS 6312:1985 用于英国通信网线路插座的插头规范
Specifies dimensions, mechanical and electrical performance and methods of test
Specification for plugs for use with British Telecommunications line jack units
FCR FED H-08-4 VOL 4-E-M-2-1988 悬垂式双工插座
PENDANT MOUNTED DUPLEX RECEPTACLE
SANS 1489:2001 防火限制式和螺栓式插头和插座
Specifies dimensional and performance requirements for flameproof restrained type and bolted type plugs, sockets and plug coupling units
Flameproof restrained and bolted type plugs and sockets
489-1982 插座 插入式电子元件 圆形
Sockets@ Plug-In Electronic Components@ Round Style
SJ 1893-1981 电子管管座、石英谐振器插座总技术条件
General specification for sockets for electronic tubes and valves and crystal units
BS 6312:1982 用于英国通信网络线路插座的插头规范
Dimensions, mechanical and electrical performance and methods of test
Specification for plugs for use with British Telecommunications line jack units
EN IEC 60309-1:2022 工业用插头、固定式或便携式插座和电器插座 第1部分：一般要求
IEC 60309-1:2021 applies to plugs, fixed or portable socket-outlets and appliance inlets hereinafter referred to as accessories, with a rated
Plugs, fixed or portable socket-outlets and appliance inlets for industrial purposes - Part 1: General requirements
IEC 60309-1:2021 工业用插头、固定式或便携式插座和电器插座 第1部分：一般要求
This document applies to plugs, fixed or portable socket-outlets and appliance inlets hereinafter referred to as accessories, with a rated operating
Plugs, fixed or portable socket-outlets and appliance inlets for industrial purposes - Part 1: General requirements
DLA MS17343 REV F-2005 壁式电插座连接器
This specification is approved for use by all Departments and Agencies of the Department of Defense The requirements for acquiring the product
CONNECTOR, RECEPTACLE, ELECTRICAL, WALL MOUNTING
DLA MIL-DTL-55302/90 F-2008 印刷电路组件和附件用连接器:极性接触件(0.100英寸间隔)直角式插座
CONNECTORS, PRINTED CIRCUIT SUBASSEMBLY AND ACCESSORIES: RECEPTACLE, RIGHT ANGLE, HERMAPHRODITIC CONTACT (.100 INCH SPACING)
T/CEEIA 517-2021 嵌入式插座
本文件规定了嵌入式插座的额定值、标志、尺寸检查、防触电保护、结构、电气性能、机械性能等技术要求。 本文件适用于户内或户外使用的、家用和类似用途的、可拆线或不可拆线、带或不带接地的、额定电压在交流50 V以上但不超过440 V、额定电流不超过16 A的嵌入式插座
Built-in socket-outlets
DLA MS90555 REV E-2003 壁式电连接器插座 等级1(电源插座)
Dimensions are in inches. Unless otherwise specified, tolerance is ± .016. For protective cover, see standard MS90563. F dimension from the front
CONNECTOR, RECEPTACLE, ELECTRICAL, WALL MOUNTING, CLASS L (POWER SOURCE RECEPTACLE)
NAVY MS24011 REV E VALID NOTICE 1-1993 20号转接18插座式接点矩形插头座
MS24011E, dated 6 December 1971, has been reviewed and determined valid for use in acquisition
CONNECTOR, RECTANGULAR, ELECTRICAL, RACK AND PANEL, 18, SIZE 20 SOCKET CONTACTS
NAVY MS24011 REV E-1971 20号转接18插座式接点矩形插头座
Dimensions are in inches
CONNECTOR, RECTANGULAR, ELECTRICAL, RACK AND PANEL, 18, SIZE 20 SOCKET CONTACTS
DLA MS90555 REV F (2)-2011 连接器，插座，电气，壁挂式，L 类（电源插座）
CONNECTOR, RECEPTACLE, ELECTRICAL, WALL MOUNTING, CLASS L (POWER SOURCE RECEPTACLE)
BS 6312:1985 用于英国通信网线路插座的插头规范
Specifies dimensions, mechanical and electrical performance and methods of test
Specification for plugs for use with British Telecommunications line jack units
FCR FED H-08-4 VOL 4-E-M-2-1988 悬垂式双工插座
PENDANT MOUNTED DUPLEX RECEPTACLE
SANS 1489:2001 防火限制式和螺栓式插头和插座
Specifies dimensional and performance requirements for flameproof restrained type and bolted type plugs, sockets and plug coupling units
Flameproof restrained and bolted type plugs and sockets
489-1982 插座 插入式电子元件 圆形
Sockets@ Plug-In Electronic Components@ Round Style
SJ 1893-1981 电子管管座、石英谐振器插座总技术条件
General specification for sockets for electronic tubes and valves and crystal units
BS 6312:1982 用于英国通信网络线路插座的插头规范
Dimensions, mechanical and electrical performance and methods of test
Specification for plugs for use with British Telecommunications line jack units
EN IEC 60309-1:2022 工业用插头、固定式或便携式插座和电器插座 第1部分：一般要求
IEC 60309-1:2021 applies to plugs, fixed or portable socket-outlets and appliance inlets hereinafter referred to as accessories, with a rated
Plugs, fixed or portable socket-outlets and appliance inlets for industrial purposes - Part 1: General requirements
IEC 60309-1:2021 工业用插头、固定式或便携式插座和电器插座 第1部分：一般要求
This document applies to plugs, fixed or portable socket-outlets and appliance inlets hereinafter referred to as accessories, with a rated operating
Plugs, fixed or portable socket-outlets and appliance inlets for industrial purposes - Part 1: General requirements
DLA MS17343 REV F-2005 壁式电插座连接器
This specification is approved for use by all Departments and Agencies of the Department of Defense The requirements for acquiring the product
CONNECTOR, RECEPTACLE, ELECTRICAL, WALL MOUNTING
编辑：北检院编辑部
