发布时间:2024-05-27 17:49:26 - 更新时间:2024年06月29日 15:22
点击量:0
本标准规定了汽车信号闪光器的要求、试验方法、检验规则等。本标准适用于M、N类汽车用信号闪光器(以下简称闪光器)。其他机动车可参照执行
Automotive signal flasher
Signal flashers for automobiles
本标准适用于标称电压为12V或24V制有拖车或拖车的机动车辆的闪光器。 本标准也可适用于摩托车
Technical conditions of automobile signal flasher
本标准适用于汽车用转向信号灯闪光器(以下简称闪光器
Turn Signal Flashers for Automobiles
本标准适用于汽车紧急停车时专为防止事故而令汽车前面及后面至少各 2 做转向信号灯同时闪光之危险警示闪光器(以下简称闪光器
Hazard Warning Signal Flashers for Automobiles
SIGNAL FLASHERS FOR AUTOMOBILES
SIGNAL FLASHERS FOR AUTOMOBILES
이 규격은 자동차용 시그널 램프의 점멸에 사용되는 시그널 플래셔에 대하여 규정한다. 다만
Signal flashers for automobiles
Red fusee for motor vehicles
Flasher units for automobiles
この規格は,トレーラを装着しない,又は装着できる,12V又は2Vの電気システムをもつ自動車に用いるフラッシャユニット(以下,フラッシャという。)の電気特性,その他製品要求事項について規定する
Automotive parts -- Flasher units
VEHICULAR HAZARD WARNING SIGNAL FLASHER
Flasher(s) referred to in this SAE Recommended Practice are for nominal 12 V or 6 V d-c circuits and are required to operate from two signal lamps
VEHICULAR HAZARD WARNING SIGNAL FLASHER
This recommended practice defines the test conditions, procedures and minimum design requirements for nominal 6, 12 and 24 volt hazard warning signal
VEHICULAR HAZARD WARNING SIGNAL FLASHER
Flashers referred to in this SAE Recommended Practice are for nominal 6 v d-c or 12 v d-c circuits as specified by the manufacturer, and are required
Vehicular Hazard Warning Signal Flasher
本标准规定了汽车信号闪光器的要求、试验方法、检验规则等。本标准适用于M、N类汽车用信号闪光器(以下简称闪光器)。其他机动车可参照执行
Automotive signal flasher
Signal flashers for automobiles
本标准适用于标称电压为12V或24V制有拖车或拖车的机动车辆的闪光器。 本标准也可适用于摩托车
Technical conditions of automobile signal flasher
本标准适用于汽车用转向信号灯闪光器(以下简称闪光器
Turn Signal Flashers for Automobiles
本标准适用于汽车紧急停车时专为防止事故而令汽车前面及后面至少各 2 做转向信号灯同时闪光之危险警示闪光器(以下简称闪光器
Hazard Warning Signal Flashers for Automobiles
SIGNAL FLASHERS FOR AUTOMOBILES
SIGNAL FLASHERS FOR AUTOMOBILES
이 규격은 자동차용 시그널 램프의 점멸에 사용되는 시그널 플래셔에 대하여 규정한다. 다만
Signal flashers for automobiles
Red fusee for motor vehicles
Flasher units for automobiles
この規格は,トレーラを装着しない,又は装着できる,12V又は2Vの電気システムをもつ自動車に用いるフラッシャユニット(以下,フラッシャという。)の電気特性,その他製品要求事項について規定する
Automotive parts -- Flasher units
VEHICULAR HAZARD WARNING SIGNAL FLASHER
Flasher(s) referred to in this SAE Recommended Practice are for nominal 12 V or 6 V d-c circuits and are required to operate from two signal lamps
VEHICULAR HAZARD WARNING SIGNAL FLASHER
This recommended practice defines the test conditions, procedures and minimum design requirements for nominal 6, 12 and 24 volt hazard warning signal
VEHICULAR HAZARD WARNING SIGNAL FLASHER
Flashers referred to in this SAE Recommended Practice are for nominal 6 v d-c or 12 v d-c circuits as specified by the manufacturer, and are required
Vehicular Hazard Warning Signal Flasher